Hinkley Lighting 4860BN User Manual

assembly instructions

Family: Piper Item No. 4860

start here

4860

Drawing 1 - Fixture Mounting

A

DE

F

Drawing 2 - Fixture Assembly

2

4

BC C

BP

1. Find a clear area in which you can work.

2. Unpack fixture and glass from carton.

3. Carefully review instructions prior to assembly.

*** The construction of this fixture will be accomplished by first attaching the
mounting strap to the junction box, making all necessary electrical connections,
assembling the main body of the fixture, mounting the fixture to the wall,
and then installing the glass.

1. Remove main mounting plate (A) from fixture back plate (B) by removing the
flat head screws (C) - see Drawing 1.

2. Slide the wires from the junction box, through the large center hole, making sure
curved slots (D) line up with the threaded holes (E) in the junction box.

3. Using two 8-32 screws (F) attach the main mounting plate (A) to the junction box,
making sure side of mounting plate (A) is perpendicular to ceiling.

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

1

Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.

1. Prior to mounting fixture to wall it is necessary to attach the reflector plate (2) to
the backplate (BP). This is done by slipping the threaded stud (B) on the back of the
reflector plate throught the vertical center holes in the backplate and threading on
the ballknobs (1) - see Drawing 2.

3

5

6

H I N K L E Y L I G H T I N G 12600 Bere a R oad Cleveland, OH 44111 8 0 0 . 4 4 6 . 5 5 3 9 / 2 1 6 . 6 7 1 . 3 3 0 0 w w w. h i nkleylighting.com

1. Mount the fixture by sliding the back plate (B) over mounting plate (A) - see

Drawing 1.

2. Attach the back plate (B) to mounting plate (A) with screws (C).

1.

Fixture can now be lamped accordingly.

To install glass, slip glass (4) over socket and over locating step (3).

2.

Note: Maximum wattage for 4860 fixture is 100 watts per bulb.

06.01.11