
Drawing 1 - Fixture Assembly
          H I N K L E Y L I G H T I N G    33000 Pin Oak Parkway  Avon Lake, OH 44012   800.446.5539 / 440.653.5500   hinkleylighting.com 
assembly instructions
4652
Family: Bolla   Item No. 4652  
start here
10
11
1 2 3
4
5
A
B
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the 
main body of the fixture, making all necessary electrical connections, hanging 
the fixture from the ceiling, and then installing the glass.
5 a 
16 
14
15
6
AAA
C
9
13
7
8
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18) 
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING 
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED 
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
1. To assemble main body, remove loop (10) and canopy plate (11) from center column  
assembly  (4).
2. Attach arms (3) to fixture column assembly (4) using lockwasher (2) and hex nut (1). 
3. Replace plate (11) and thread loop (10) onto center column assembly (4).
4. Remove ball knob (5) from top of cluster assembly (A). Place diffuser (5a) on top and 
attach using ball knob (5) removed earlier. 
5 . Please refer to the hanging instruction sheet (I.S. 19) provided to continue  
installation of this fixture. Then refer back to this sheet to install glass.
1. Prior, to installing glass, fixture can now be lamped.
2. To install glass, slip stem (13) with decorative ball knob (8) through center hole of 
bottom assembly (7).
3. Slip glass (6) over nipple (13) and into bottom assembly (7).
4. Slip rubber washer (14), followed by steel washer (15) onto stem (13).
5. Thread hex nut (16) onto stem (13) and tighten to secure glass (6) to bottom 
assembly (7).
6. Line up the holes on bottom of arms (C) with the threaded stud (B) extending out  
from end of arm (3).
7. Slip holes (C) in bottom assembly (7) arms over studs (B) and hold in position.
8. Thread ball knob (9) onto end of stud (B).
2.7.08