Hinkley Lighting 3440PN User Manual

Drawing 1 - Fixture Mounting

assembly instructions

3440

Item No. 3440

start here

J

A

B C D

Drawing 2 - Glass Installation

1

2

3

back plate

E F

1. Find a clear area in which you can work.

2. Unpack xture and glass from carton.

3. Carefully review instructions prior to assembly.

*** The construction of this xture will be accomplished by rst attaching the
mounting strap to the junction box, making all necessary electrical connections,
mounting the xture to the wall, and then installing the glass.

1. Prepare mounting strap (A) by threading the two 1 1/4” long mounting screws (B)
into the back of the mounting strap (A) - see Drawing 1.

• Be sure the holes into which the screws are threaded match the spacing of holes (D)
in the backplate (E).

2. Attach mounting strap (A) to junction box (J) using two 1” screws (C).

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)

AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING

INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED

ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Make electrical connections from supply wire to xture lead wires. Refer to instruction sheet (I.S.

18) and follow all instructions to make all necessary wiring connections. Then refer back to this

sheet to continue installation of this xture.

4

5

HINKLEY LIGHTING 33000 Pin Oak Parkway Avon Lake, Ohio 44012 800-446-5539 www.hinkleylighting.com

1. To mount xture, slip the two mounting screws (B) through the two mounting holes (D) in the
backplate (E) - see Drawing 1.

2. While holding xture in place, thread the two ball knobs (F) on to the end
of the mounting screws (B), and tighten.

1. to install glass rst remove socket ring (1) and spacer (2) from socket (4).

2. Slip glass (3) over socket (4) followed by spacer (2).

3. Thread socket ring (1) back onto socket (4) and tighten till snug.

6.1.12