Hinkley Lighting 2041 User Manual

Drawing 1 - Roof Installation & removal

1

2

2

2

2

2

4

Drawing 2 - Glass Installation

3

9

assembly instructions

2041

Item No. 2041

start here

1. Find a clear area in which you can work.

2. Unpack xture and glass from carton.

3. Carefully review instructions prior to assembly.

*** The construction of this xture will be accomplished by rst installing the glass, making
all necessary electrical connections, and then mounting the
xture to the pole.

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)

AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING

INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED

ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Make electrical connections from supply wire to xture lead wires. Refer to instruction sheet (I.S.

18) and follow all instructions to make all necessary wiring connections. Then refer back to this

sheet to continue installation of this xture.

7

6

Drawing 3 - Fixture Mounting

8

1. To install glass, it is necessary to remove the roof (2) rst. This is accomplished by rst unthread-

ing top knob (1) - see Drawing 1.

2. Roof (2) can now be lifted o the cage of the xture.

3. To remove cross bar and center tube assembly (3), unthread ball knob studs (4).

4. Set these parts aside in a safe place to be re-installed later.

1. To install glass panels (7), slip them up through the open top of the cage (6). see Drawing 2.

2. Slip bottom of glass panels (7) into channel (8) in bottom of cage (6) tip top of panel into
position, and bend over clips (9) to secure glass in cage. Repeat procedure for remaining panels of
glass.

3. Fixture is ready for installation, roof (3) can be installed after the xture is mounted to the pole
by following Step 3 in reverse order.

1. After wiring connections are complete, slip post tter (A) over top of pre-installed post (B)
making sure all wire connections are tucked inside the pole - see Drawing 3.

2. When xture is slipped over pole make sure no wires are being pinched between the top edge of
the pole and the inside of the post tter.

3. Thread the 3 screws (C) into pre-tapped holes in post tter.

4. Tighten screw (C) to secure xture to post.

6.1.12

HINKLEY LIGHTING 133000 Pin Oak Parkway, Avon Lake, OH 44012 800.446.5539 www.hinkleylighting.com