Hinkley Lighting 1982 User Manual

Drawing 1 - Glass Replacement

12

assembly instructions

1982

Item No. 1982

start here

1. Find a clear area in which you can work.

13

2. Unpack xture and glass from carton.

3. Carefully review instructions prior to assembly.

1

5

4

1

*** The construction of this xture will be accomplished by rst making all necessary
electrical connections, and then hanging the xture from the ceiling.

6

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)

11

AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING

INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED

ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Make electrical connections from supply wire to xture lead wires. Refer to instruction sheet (I.S.

18) and follow all instructions to make all necessary wiring connections.

Then refer to the hanging instruction sheet (I.S.) provided to complete installation
of this xture.

Glass Replacement Instructions - see Drawing 1.

1. Remove roof (2) from cage (1) by unscrewing the phillips heads screws (3) on top edge of roof.

2. Remove the glass clips (4) by removing the screws (5) that hold them in place.

3. Pull up on glass panel (6) and remove.

4. To replace the glass follow steps 1-3 in reverse order.

6.1.12

HINKLEY LIGHTING 33000 Pin Oak Parkway, Avon Lake, OH 44012 800.446.5539 www.hinkleylighting.com