Hinkley Lighting 16804 User Manual

ENCLOSURE

ENCLOSURE

ENCLOSURE

LAMP

LAMP

GUARD

LV-E installation instructions

LV-E

Drawing 1

start here

LENS

GUARD

INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO
PERSONS, IMPORTANT SAFETY INSTRUCTIONS.

Lighted lamp is HOT!

WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS:

• Turn off/unplug and allow to cool before replacing lamp.

• Lamp gets HOT quickly! Contact only switch/plug when turning on.

• Do not touch hot lens, guard, or enclosure - see Drawing 1.

• Keep lamp away from materials that may burn.

• Do not touch the lamp at any time. Use a soft cloth. Oil from skin may

damage lamp.

• Do not operate the luminaire fitting with a missing or damaged shield.

• Luminaires shall not be installed within 10 feet (3m) of a pool, spa or
fountain.

• Do not use tungsten halogen lamps unless the luminaire is marked for
halogen use.

SAVE THESE INSTRUCTIONS

2

HINKLEY LIGHTING 12600 Berea Road Cleveland, OH 44111 800.446.5539 / 216.671.3300 www.hinkleylighting.com

This Luminaire is provided with (2) wirenuts and silicone glue for use to
connect the luminaire to supply wires from the transformer. Apply silicone
glue to the inside of the wirenut before twisting onto wires.

The main low voltage cable from the transformer is to be:

1. Protected by routing in close proximity to the luminaire or fitting, or next to
a building structure such as a house or deck.

2. Not be buried except for a maximum 6 inches (15.2 cm) in order to connect
to the main low voltage cable

3. Have the length cut off so that it is connected to a connector within 6 inches
(15.2 cm) from a building structure, a luminaire, or fitting.