Hinkley Lighting 15450SW User Manual

Electrical Connections

(A) LED

Driver

(C) Mounting
Plate

(B) Extension

Tube

Fixture Mounting

Mounting screws
(supplied with
Junction Box)

Extension Tube Replacement

(E) Retaining

Nut

(B) Extension
Tube

I.S. 155 Nexus Sign Light

Mounting Instructions

start here

SAFETY WARNING: TURN POWER SUPPLY OFF DURING INSTALLATION. IF
NEW WIRING IS REQUIRED, CONSULT A QUALIFIED ELECTRICIAN OR LOCAL
AUTHORITY FOR CODE REQUIREMENTS.

IMPORTANT OPERATION NOTE: THIS LIMINAIRE IS DESIGNED TO BE

OPERATED WITH HINKLEY APPROVED LED DRIVERS. CONNECTING LED TO
STANDARD INCOMIMG 120VOLT SUPPLY WITHOUT THE USE OF THE DRIVER
WILL RESULT IN FAILURE OF LEDS

1. Find a clear area to work.

2. Unpack fixture from carton.

3. Carefully review instructions prior to assembly.

Electrical Connections:

1. The fixture is supplied with a constant voltage LED driver (A). Feed
Fixture wires through Extension Tube (B) and Mounting Plate (C).

Driver Wire:

Black wire = (-) Negative Red wire = (+) Positive

**You may connect either black wire from the fixture to the red or the black
driver wire. The internal circuitry will correct polarity.

When two drivers are used each driver must be wired separately.
There be two sets of fixture wire for this purpose.

The other set of Black and White wires are to be connected to the
Incoming Black and White supply wires. The driver is designed to
“Float” inside the junction box.

Fixture Mounting:

1. Make electrical connections according Electrical Connections above.

2. Attach the Fixture (D) to the Extension tube (B) by turning it onto the
threaded stem that is attached to the fixture.

3. Holes in Mounting Plate (C) should line up with mounting ears on
junction box. Using screws supplied with junction box attach mounting
plate. Tighten screws until snug.

4. It is important to seal the joint between the mounting plate and the
mounting surface with the appropriately rated silicone for the surface
being applied to.

Extension Tube Replacement :
Your fixture is supplied with two Extension tubes. One is

3 inches long and the other one is 6 inches long. If you want
to use the shorter or the longer tube you will need to remove
the retaining nut (E) on the backside of the Mounting plate
and then replace the existing tube.

IS155 Created 8/28/12 RI
Rev A – 4/15/2013