Hilti CC410EP INSTALLATION

8.2.7

Construction Chemicals

CC410EP Water -Based Epo xy Skidpr oofer

Basic Use

CC410EP is a three-component, water-based epoxy skidproof er
designed for concrete floors, wood dec ks and other w alking sur­faces, including shower and locker rooms.

Limitations

• CC410EP should not be used in place of an elastromeric
waterproofing membrane.Waterproofing membranes are
designed to bridge small moving cracks.

• CC410EP must not be permitted to freeze prior to application.

• Do not place CC410EP when slab temperatures are below
55°F or above 90°F, or when relative humidity is above 75%.

• Material should be placed within 1 hour after mixing.

8.2.7.3 INSTALLA TION DATA

Surface Preparations

Surfaces to be coated with CC410EP must be clean and free of
surface contamination, such as dust, dirt and laitance.Surfaces
may be damp, b ut there m ust be no standing water.

Concrete surfaces may be prepared b y high pressure w ater
cleaning, wire brushing, sand or shot blasting, or acid etching.If
acid etching is chosen, the surface must be thoroughly rinsed
with clear water afterward, to remove all tr aces of m uriatic acid.

Wood surfaces may be prepared by sanding lightly to open the
grain.

Where previously applied coatings are present, in many cases
they may remain in place if desired.The coatings must be firmly
bonded, and a test patch of CC410EP must be applied to deter­mine adhesion.Prior to application of CC410EP, the coating
must be wire brushed or scarified, then cleaned.

Mixing

Combine Part A, Part B and aggregate and mix thoroughly,
using a TE-25 and a Hilti mixing paddle.

Application

CC410EP may be rolled, brushed, or spray ed onto surfaces.If
rolling, choose a roller with a 1/4" nap for best results.

8.2.7.4 INSTALLA TION INSTRUCTIONS