Hillsdale Furniture 50833H Assembly Guide
Date: 03-15-07
HILL
SD
FURNITURE, LLC.
Examine all packaging material for small parts that may have come loose during shipment. Periodic checks are recommended to insure
that all components are in proper position, tight and free from damage. Keep this assembly instruction for future reference. Adult
assembly required. Customer Service Phone Number: 502-562-0000
ALE
SPARTA VANITY STOOL
Model #50833
HARDWARE LIST
(8) Large Camber Washers
A
(4) Small Camber Washers
B
(14) Spring Washers
C
(4) Short Allen Bolts
D
(8) Medium Allen Bolts
E
(2) Long Allen Bolts
F
(2) Flat Washers
G
(4) Wood Screws
H
(1) Allen Wrench
I
J
PARTS LIST
(1) Stool Back Panel
J
(1) Stool Seat Base
K
(4) Legs
L
(1) Cross Brace
M
(1) Seat Cushion
N
N
CBA
GFE
H
ID
* * * ASSEMBLY * * *
STEP 1
Begin assembly by attaching Stool Back
Panel (J) to Stool Seat Base (K), using
1 Long Allen Bolt (F), 1 Spring Washer
(C) & 1 Flat Washer (G) on each bottom
end. Tighten all bolts for this step.
G
C
F
STEP 2
Next, attach all 4 Legs (L) to Stool Seat
Base (K), using 2 Medium Allen Bolts
(E), 2 Spring Washers (C) & 2 Large
K
L
L
M
B
C
D
A
C
E
A
C
E
L
H
L
Camber Washers (A) per each leg. Only
hand tighten bolts for this step.
STEP 3
Next, attach Cross Brace (M) to each
Leg (L), using 1 Short Allen Bolt (D), 1
Spring Washer (C) & 1 Small Camber
Washer (B) per each leg. Tighten all bolts
from Steps 1 - 3 here.
STEP 4
Finally, attach Seat Cushion (N) to Stool
Seat Base (K), using 4 Wood Screws (H)
to hold tight in place. Only tighten using
phillips head screwdriver to prevent overÂtightening.
Assembly of your new Vanity Stool is now
complete. You may need to adjust the foot glides
(located on bottom of each leg) to properly level
this stool to your sitting preference. Please keep
this Assembly Instruction Sheet for any future
use or information.
CARE & MAINTENANCE: The touch of a soft cloth is all the maintenance the finish will ever need. Please do not use harsh or abrasive cleaners for
polishing, as they may cause damage to the finish. Periodic checks are recommended to make sure that all bolts, screws and nuts are securely tightened.
Loading...