Hills Heritage Hoist 4, Heritage Hoist 5 Product Manual

HeritageTM Hoist

Secondary Standard
Replacement

Product Manual

TO SUIT MODELS:

Heritage Hoist 4

Heritage Hoist 5

Part name Qty.

Secondary Standard 1

Conical Nylon Washer 1

Pack Contents

PD2278b_Heritage Secondary Standard Replacement_Manual_PRINT.indd 1 19/10/11 10:27 AM

2

Heritage Hoist Secondary Standard Replacement

Important: Support the Hoist securely

before undoing the case retaining bolts
and nuts. You will require the assistance of
another person to perform this task.

To remove:

1. Wind down the Hoist to its minimum

height.

2. Support the upper section and remove

the case retaining bolts and nuts.
Separate the two case halves. Fig. 1.

3. Lift the upper section of the hoist off of

the bottom main standard and place
upside down on the ground.

4. Remove the Top Cap retaining screw and

the Cross retaining screw. Place to one
side as they are to be re used. Lift the
Arm, Stay and Wire assembly off of the
Secondary Standard. Place to one side.

Fig. 1.

5. Undo the Wind Brake retaining screw and

slide the Wind Brake and Bush off of the
end of the Secondary Standard. Fig. 2.

6. Slide the Top Main Standard off of the

Secondary Standard.

7. Unhook the Secondary Standard from

the Worm and Crown assembly and
discard Secondary Standard. Fig. 3.

Cross

Secondary Standard

Top Cap

Top Main Standard

Case Retaining Bolts

Cross Retaining Screw

Top Cap Retaining Screw

Bottom Main Standard

Plain Case

Case Retaining Nuts

Handle and
Case Assembly

Fig. 1

PD2278b_Heritage Secondary Standard Replacement_Manual_PRINT.indd 2 19/10/11 10:27 AM

3

Secondary Standard Replacement Heritage Hoist

Secondary
Standard

Secondary
Standard

Conical Nylon
Washer

Worm and
Crown assembly

Wind Brake Wind Brake

Retaining
Screw

Top Main
Standard

Top Main
Standard

Winding
Mechanism

Bush

Fig. 2 Fig. 3

PD2278b_Heritage Secondary Standard Replacement_Manual_PRINT.indd 3 19/10/11 10:27 AM