Hills EVOHD-H-VDIR-WDR-MZ-2.812, EVO HD Installation And Operation Manual

Installation and Operation Guide

Full HD WDR Vandal-Proof Camera

EVOHD-H-VDIR-WDR-MZ-2.812

FCC COMPLIANCE STATEMENT

WARNING : This is a Class A product. In a domestic environment this product may

cause radio interference in which case the user may be required to take adequate
measures.

CAUTION : Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.

FCC INFORMATION : This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference
at his own expense.

This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.

CE COMPLIANCE STATEMENT

2

IMPORTANT SAFETY INSTRUCTIONS

1. Read these instructions.

2. Keep these instructions.\

3. Heed all warnings.

4. Follow all instructions.

5. Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions.

6. Do not install near any heat sources such as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce heat.

7. Only use attachments/accessories specified by the manufacturer.

8. Use only with the cart, stand, tripod, bracket, or table specified by
The manufacturer, or sold with the apparatus. When a cart is used,
Use caution when moving the cart/ apparatus combination to avoid
Injury from tip-over.

9. CAUTION – THESE SERVICING IN STRUCTIONS ARE FOR USE BY QUALIFIED
SERVICE PERSONNEL ONLY. TO REDUCE THE RISK OF ELECTRIC SHOCK DO
NOT PERFORM ANY SERVICING OTHER THAN THAT CONTAINED IN THE
OPERATING INSTRUCTIONS UNLESS YOU ARE QUALIFIED TO DO SO.

10. Use satisfy clause 2.5 of IEC60950-1/UL 60950-1 or Certified/Listed Class 2
power source only.

11. Indoor use only.

EXPLANATION OF GRAPHICAL SYMBOLS

The lighting flash with arrowhead symbol, within an equilateral triangle, is

Intended to alert the user to the presence of uninsulated “dangerous voltage”

within the product`s enclosure that may be of sufficient magnitude to constitute
a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user
to the presence of important operating and maintenance (servicing)
instructions in the literature accompanying the appliance.

LIMITATION OF LIABILITY

THE INFORMATION IN THIS PUBLICATION IS BELIEVED TO BE ACCURATE IN ALL
RESPECTS; HOWEVER, WE CANNOT ASSUME RESPONSIBILITY FOR ANY
CONSEQUENCES RESULTING FROM THE USE THEREOF. THE INFORMATION
CONTAINED HEREIN IS SUBJECT TO CHANGE WITHOUT NOTICE. REVISIONS OR
NEW EDITIONS TO THIS PUBLICATION MAY BE ISSUED TO INCORPORATE SUCH
CHANGES.

3

PRECAUTIONS

Before installation, carefully read the manual to ensure correct operation and setup,
heeding all warnings and instructions.

Do not block any ventilation openings. Install in accordance with the manufacturer's
instructions.

Ensure manual is kept in good condition for future use.
Do not install the device near any heat sources such as radiators, heat registers, stoves,

or other equipment(including amplifiers) that produce heat.
Only use attachments/accessories specified by the manufacturer.
Should any liquid get into the housing, immediately disconnect the device from the power

supply and have it
checked by authorized personnel before reusing.
Do not install the device in a place where it is exposed to gas or oil.
Installation and servicing by authorized personnel only, adhering to local safety regulations.
Unless you are an authorized technician, never try to dismantle the device. To avoid

electric shock, never remove the screws or covers.
If a camera, do not expose the device to radioactivity. It will cause serious damage to the

CCD.
Use Certified/Listed Class 2 power source only.

Cleaning

Clean the device with a slightly damp soft cloth. Use a mild household detergent. Never
use strong solvents such as thinner or benzene as they might damage the finish of the unit.

4

TABLE OF CONTENTS

INTRODUCTION ------------------------------------------------------------------------- 6
CAMERA CONNECTION -------------------------------------------------------------- 7
LENS ADJUSTMENT ------------------------------------------------------------------- 7
CONTENTS OF PACKAGE ----------------------------------------------------------- 8
INSTALLATION --------------------------------------------------------------------------- 9
STRUCTURE OF THE SETUP MENU --------------------------------------------- 11
DC AUTO IRIS LENS ------------------------------------------------------------------- 17
SPECIFICATIONS ----------------------------------------------------------------------- 18
EXTERNAL DIMENSION ------------------------------------------------------------ 19

5

INSTRUCTION

IMPORTANT : The user of this camera is responsible for checking and

complying with local, state, and federal laws and statutes concerning the
recording and monitoring of audio signals.

The 1/2.8” 2.1M Full HD CMOS camera, especially for closed circuit television
CCTV and security surveillance application.

Features:

• High performance SONY 1/2.8” 2.1M STARVIS CMOSTM

• Min. illumination 0.03 lux(Color), 0 lux(BW, IR LED ON)

• Auto electronic shutter [1/30(1/25) ~ 1/30,000] and manual electronic shutter modes

• WDR (Wide Dynamic Range)

• D-WDR (Digital Wide Dynamic Range)

• BLC (Back-light compensation)

• HLC (High-light compensation)

• Auto and manual white balance modes (AUTO/AUTOext/Manual/AWB)

• Day & Night (ICR) : Auto / Color / BW /EXTERN

• OSD (on screen display)

• DNR (Digital Noise Reduction)

• IR Range distance up to 30M

• 30EA, 850nm IR LEDs

• Privacy mask Function (16zone)

• Motion Detection (4zone)

• Defog

• Composite Video Output (700TV Lines)

• Operates in AC24V ± 10% / DC 12V ± 10%

• Use Certified / Listed Class 2 Power source only

６