ANS Z 21.97-2010, Outdoor Decorative Gas Appliances
CGA CR 97-003 Outdoor Gas Fireplaces
Questions, problems, missing parts? Before returning to your retailer, call our customer
service department at 1-888-775-1330, 7 a.m. - 4 p.m., PST, Monday - Friday.
1
US
PACKAGE CONTENTS
A
B
C
D
E
F
G
J
K
L
M
N
OI
A
B
C
D
E
F
G Front Bracket Post (Left)
H
I
Front Bracket Post (Right)
Side Panel
J
K
L
M
N
O
Bottom plate
Door (Left)
Door Handle
Door (Right)
H
Cover
Burner Assembly
1/4 Table
Angle Iron
Door Bracket
Back Bracket Post (Left)
Back Bracket Post (Right)
Gas Cylinder Block Belt
NOITPIRCSED TRAP QUANTITY
1
1
4
4
1
1
1
1
1
3
1
1
1
2
1
2
HARDWARE CONTENTS (shown actual size)
DANGER
DANGER
DANGER
AA
BB
CC
DDEE
FF
M6 nut
washer Φ4
Qty. 4
Screw
M4 X 8
Qty. 5
Bolt
M6 X 30
Qty. 4
GGHHII
Wrench
Qty. 1
Propane
Tank Strap
Qty. 1
Glass
(One Pack)
Qty. 1
Qty. 8
Door Handle
Qty. 2
N
Bolt
M6 X 12
Qty. 40
P
Knob
Qty. 1
Screw
M5 X 8
Qty. 4
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install
the product. If you have any questions regarding the product, please call customer service at
This appliance has been tested to and complies with the ANS Z 21.97-2010, Outdoor Decorative
Gas Appliances CGA CR 97-003 Outdoor Gas Fireplaces. The installation must conform to local
codes or the absence of local codes to the National Fuel Gas Code. ANS Z223.1.This manual
contains important information about the assembly, operation and maintenance of this fire pit. General
safety information is presented in these first few pages and is also located throughout the manual.
Keep this manual for future reference and to educate new users of this product. This manual should
be read in conjunction with the labeling on the product. Safety precautions are essential when any
mechanical or propane fueled equipment is involved. These precautions are necessary when using,
storing, and servicing. Using this equipment with the respect and caution demanded will reduce the
possibilities of personal injury or property damage. The following symbols shown below are used
extensively throughout this manual. Always heed these precautions, as they are essential when using
any mechanical or fueled equipment.
DANGER indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
Failure to comply with the precautions and instructions
provided with this fire pit can result in death, serious
bodily injury and property loss or damage from
hazards of fire, explosion, burn, asphyxiation, and/or
carbon monoxide poisoning. Only persons who can
understand and follow the instructions should use or
service this fire pit.
FOR YOUR SAFETY
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. If odor continues, keep away from the appliance and
immediately call you gas supplier or fire department.
Solid fuels shall hot be burned in this appliance.
3
SAFETY INFORMATION
DANGER
WARNING
DANGER
WARNING
WARNING
DANGER
WARNING
• EXPLOSION - FIRE HAZARD
• Keep solid combustibles, such as building materials,
paper or cardboard, a safe distance away from the
fire pit as recommended by the instructions.
• Provide adequate clearances around air openings
into the combustion chamber.
• Never use the fire pit in spaces which do or may
contain volatile or airborne combustibles, or products
such as gasoline, solvents, paint thinner, dust particles
or unknown chemicals.
• During operation, this product can be a source of
ignition. Keep fire pit area clear and free from
combustible materials, gasoline, paint thinner, cleaning
solvents and other flammable vapors and liquids. Do
not use fire pit in areas with high dust content.
Minimum fire pit clearances from combustible
materials: two (2) feet from the sides & two (2) feet
from the rear, 6 feet from ceiling.
• EXPLOSION - FIRE HAZARD
• Never store propane near high heat, open flames,
pilot lights, direct sunlight, other ignition sources or
where temperatures exceed 120 degrees F (49°C).
• Propane vapors are heavier than air and can
accumulate in low places. If you smell gas, leave the
area immediately.
• Never install or remove propane cylinder while fire pit
is lighted, near flame, pilot lights, other ignition sources
or while fire pit is hot to touch.
• This fire pit is red hot during use and can ignite
flammables too close to the burner. Keep flammables
at least 2 feet from sides & 2 feet from rear, 6 feet
from ceiling. Keep gasoline and other flammable liquids
and vapors well away from fire pit.
• Store the propane cylinder outdoors in a well ventilated
space out of reach of children. Never store the propane
cylinder in an enclosed area (house, garage, etc.). If
fire pit is to be stored indoors, disconnect the propane
cylinder for outdoor storage.
We cannot foresee every use which may be made of
our fire pit.
Check with your local fire safety authority if you have
questions about fire pit use.
Other standards govern the use of fuel gases and heat
producing products for specific uses. Your local
authorities can advise you about these.
If no local codes exist, follow National Fuel Gas Code,
ANS Z223.1. In Canada, installation must conform to
local codes. If no local codes exist, follow the current
National standards of CANADA CAN/CGA-B 149.2.
• CARBON MONOXIDE HAZARD
• This fire pit is a combustion appliance. All combustion
appliances produce carbon monoxide (CO) during the
combustion process. This product is designed to produce
extremely minute, non-hazardous amounts of CO if used
and maintained in accordance with all warnings and
instructions. Do not block air flow into or out of the fire pit.
• Carbon Monoxide (CO) poisoning produces flu-like
symptoms, watery eyes, headaches, dizziness, fatigue
and possibly death. You can't see it and you can't
smell it. It's an invisible killer. If these symptoms are
present during operation of this product get fresh air
immediately!
• For outdoor use only.
• Never use inside house, or other unventilated or
enclosed areas.
• This fire pit consumes air (oxygen). Do not use in
unventilated or enclosed areas to avoid endangering
your life.
WARNING indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
An LP-cylinder not connected for use shall not be
stored in the vicinity of this or any other appliance.
WARNING: For Outdoor Use Only
DANGER
Improper installation, adjustment, alteration, service or
maintenance can cause property damage, injury or
death. Read the installation, operation and
maintenance instructions thoroughly before installing
or servicing this equipment.
CARBON MONOXIDE HAZARD
This appliance can produce
carbon monoxide which has
no odor. Using it in an enclosed
space can kill you. Never use this
appliance in an enclosed space
such as a camper, tent or home.
4
WARNING
WARNING
WARNING
WARNING
SAFETY INFORMATION
CAUTION
CAUTION
WARNING
California Proposition 65
Combustion by-products produced when using
this product contain chemicals known to the State
of California to cause cancer, birth defects, and
other reproductive harm.
BURN HAZARD
• Never leave fire pit unattended when hot or in use.
• Keep out of reach of children.
Certain materials or items, when stored under the
fire pit, will be subjected to radiant heat and could be
seriously damaged.
SERVICE SAFETY
• Keep all connections and fittings clean. Make sure
propane cylinder valve outlet is clean.
• During set up, check all connections and fittings for
leaks using soapy water. Never use a flame.
• Use as a heating appliance only. Never alter in any
way or use with any device.
CAUTION indicates an imminently hazardous situation
which, if not avoided, may result in minor or moderate
personal injury, or property damage.
• This product is fueled by propane gas. Propane gas
is invisible, odorless, and flammable. An odorant is
normally added to help detect leaks and can be
described as a “rotten egg” smell. The odorant can
fade over time so leaking gas is not always detectable
by smell alone.
• Propane gas is heavier than air and leaking propane
will sink to the lowest level possible. It can ignite by
ignition sources including matches, lighters, sparks or
open flames of any kind many feet away from the
original leak. Use only propane gas set up for vapor
withdrawal.
• Store or use propane gas in compliance with local
ordinances and codes or with ANS/NFPA 58. Turn off
propane when not in use.
• Alert children and adults to the hazards of high surface
temperatures. Stay away from these surfaces to avoid
burning skin or igniting clothing.
• Carefully supervise young children when in the vicinity
of the fire pit.
• Do not hang clothing or any other flammable materials
from the fire pit, or place on or near the fire pit.
• Replace any guard or protective device removed for
servicing the appliance prior to placing back in service.
• Installation and repair should be done by a qualified
service person. The fire pit should be inspected
before use and annually by a qualified service person.
More frequent cleaning may be required as necessary.
It is imperative that the control compartment, burners,
and circulating air passageway of the appliance be
kept clean.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and hardware contents above. If any part is missing or damaged, do not
attempt to assemble the product. Contact customer service for replacement parts.
Estimated Assembly Time: 60 minutes
Tools Required for Assembly (not included):
Phillips screwdriver w/ medium blade. Leak Detection Solution.
5
ASSEMBLY INSTRUCTIONS
1. Attached a door handle (N) to one door (left) (M) with
two Φ4 washers (AA) and two M4 X 8 screws (BB).
Repeat procedure to complete the assembly of the other
door (right) (O).
Hardware Used
AA
BB
2. Attach a angle iron (D) to 1/4 table (C) with M6 X 12
bolt (EE). Repeat procedure to complete the assembly of
the rest of three 1/4 tables.
Washer Φ4
Screw M4 X 8
x 4
x 4
1
2
M
N
D
O
Hardware Used
EE
Bolt M6 X 12
3. Line up holes in 1/4 table with corresponding holes
the other 1/4 table, insert two M6 X 12 bolts (EE) through
holes, finger tighten two M6 nuts (DD) . Be sure that line
① and line ② are in the same level and fully tighten
bolts. Use another two M6 X 12 bolts to fasten the two
1/4 tables. Repeat procedure to complete the assembly of
the rest of 1/4 tables.
Hardware Used
x 4
C
3
2
1
EE
Bolt M6 X 12
DD
Nut M6
x 12
x 8
6
Loading...
+ 14 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.