HiHippo CM-140 GE, CB-140 GE User Manual

CM-030 GE / CB-030 GE

Progressive Scan

656 x 494 90 FPS GigE Vision

PRELIMINARY

Member of C3 Compact series, covering VGA to UXGA resolution 
656 (h) x 494 (v) 7.4 µm square pixels 
1/3” progressive scan – Monochrome and Bayer mosaic color versions 
90 frames/second with external trigger and full resolution 
Increased frame rate with vertical binning (CM-030 GE) and partial scan 
Exposure time from 21.6 µs to 2 sec. using Pulse Width trigger mode 
Programmable exposure from 43.2 µs to 11.037 ms in Full Frame scan 

Sequencer trigger mode for on-the-y change of gain, exposure and ROI 

LVAL-synchronous/-asynchronous operation (auto-detect) 
Auto iris lens video output allows a wider range of light 
GigE Vision interface with 10 or 8-bit output 

Programmable GPIO with opto-isolated inputs and outputs 

Comprehensive software tools and SDK for Windows XP/Vista 

www.jai.com

GigE

POWER / TRIG

Outside size tolerance?F±0.3mm

13

26 26

14.5

(0.57)

(0.51)

5

(0.2)

(1.02) (1.02)

59

75

Serial No.

6-M3depth4

(depth0.16)

FCC seal

Caution seal

673-M3depth4

5

(0.2) (2.64)

(2.95)

(2.32)

Specications for CM-030 GE / CB-030 GE

GigE

POWER / TRIG

44

29

C-Mount

(1.73)

(1.14)

14.5

(0.57)

(depth0.16)

75

FCC seal

673-M3depth4

5

(0.2) (2.64)

(2.95)

GigE

POWER / TRIG

14.5

(0.57)

75

FCC seal

673-M3depth4

5

(0.2) (2.64)

(2.95)

GigE

POWER / TRIG

R

G

B

IR stop

Specications CM-030 GE / CB-030 GE

Sensor 1/3” progressive scan CCD
Pixel Clock 40 MHz

Frame rate full frame 90.5 frames/second

Active area 4.9 (h) x 3.7 (v) mm
Cell size 7.4 (h) x 7.4 (v) µm
Active pixels 656 (h) x 494 (v)
Color (CB-200 GE) Raw Bayer output, host based interpolation
Read-out modes

1/2 partial scan
1/4 partial scan
1/8 partial scan
2/3 partial scan
Vertical binning

Region-of-interest (ROI)

Sensitivity (CM-030GE) 0,004 Lux Lux (On sensor, max. gain,

Sensitivity (CB-030GE) 1,21 Lux Lux (On sensor, max. gain,

S/N ratio >50dB (0 dB gain)
Video output GigE Vision, 8-bit or 10-bit
Auto-iris lens video output 0.7 Vp-p, enabled by internal switch

Gain Manual/Automatic

Synchronization Internal X-tal, External hardware trigger

GPIO Module

Input/output switch

Clock generator (one)

Pulse generators (four)

Hardware trigger modes Continuous, Pre-Select, Pulse Width, Frame

Electronic shutter

Pre-set shutter

Programmable exposure

Exposure Time (Abs)

Pulse Width

GPIO plus Pulse Width Register based

Functions controlled via
GigE Vision interface

GigE Vision streaming
control

Indicators on rear panel Power / Hardware trigger,

Operating Temperature -5°C to +45°C
Humidity (operation) 20 - 90% non-condensing
Storage temp./humidity -25°C to +60°C / 20 to 90%
Vibration 10 G (20Hz to 200 Hz XYZ)
Shock 70G
Regulations CE (EN 61000-6-2, EN-61000-6-3), FCC part

Power 12V DC +/-10%. 3.6 W
Lens mount C-mount

Dimensions (H x W x L) 29 x 44 x 75 mm
Weight 125 g

Europe, Middle East & Africa

Phone [phone]
Fax [phone]

Visit our web site on www.jai.com

Full

Configurable 14-in/9-out switch (LUT)

12-bit counter based on 25MHz clock or

20-bit counters programmable for length,

2L (43.2µs) to 511L (11.037ms) in 1L steps

max. 2 sec (Can be set by 100µs unit or

Packet size, Delayed (frame) Readout,

Asia Pacic

Phone [phone]
Fax [phone]

(511 lines/frame)

656 (h) x 494 (v) 90.5 fps

656 (h) x 246 (v) 159 fps
656 (h) x 122 (v) 255 fps

656 (h) x 62 (v) 361 fps

656 (h) x 326 (v) 128

656 (h) x 247 (v) 166.2 fps*

User definable. Memory read-out

* NOTE: CM-030 GE only

shutter off, 50% video)

shutter off, 50% video)

Range -3 to +12 dB

via GPIO

Software trigger via GigE Vision

Pixel Clock

start point, stop point, repeat

Delay,

Sequence (Gain, Shutter, ROI)

1/90 to 1/10,000 in 9 steps

Same range as PE

Pixel Clock unit)

GigE Vision (GenICam compliant)

Shutter, Gain, Black level,

Trigger mode, Readout mode,

GPIO setup, ROI

(GenICam mandatory functions)

Inter-packet delay

GigE link, GigE activity

15 class B, RoHS/WEEE

Americas

Phone (Toll-Free) 1 800 445 5444
Phone [phone]

Connector pin-out

DC In / GPIO

HIROSE HR10A-10R-12PB-01

Dimensions

Front view

Side view

Connector Pin-out
Pin 1 GND
2 +12 V DC input
3 Opto in 2(-)*/GND
4 Opto in 2(+)*/Auto iris lens
5 Opto in 1(-)
6 Opto in 1(+)
7 Opto out 1(-)
8 Opto out 1(+)
9 Opto out 2(-)
10 Opto out 2(+)
11 +12V DC input
12 GND

* Pins 3 and 4 can be congured

by internal switch selection

Bottom view

GigE Vision interface

Accepts RJ-45 with thumbscrews

Rear view

Pin 1 TRD+(0)
2 TRD–(0)
3 TRD+(1)
4 TRD+(2)

5 TRD–(2)
6 TRD–(1)
7 TRD+( 3)
8 TRD–(3)

Spectral Response CM-030GE Spectral Response CB-030GE

Ordering Information

CM-030 GE 1/3” Monochrome Progressive Scan Camera
CB-030 GE 1/3” Bayer Mosaic Color Progressive Scan Camera

Company and product names mentioned in this datasheet are trademarks or registered trademarks of their respective owners.

JAI A·S cannot be held responsible for any technical or typographical errors and reserves the right to make changes to products and documentation without prior notification.

31014811.09.07.3000