HiHippo CM-200 GE, CB-200 GE User Manual

Progressive Scan

CM-040 GE / CB-040 GE

CM-040 GE / CB-040 GE

Progressive Scan

776 x 582 61 FPS GigE Vision

PRELIMINARY

Member of C3 Compact series, covering VGA to UXGA resolution 
776 (h) x 582 (v) 8.3μm square pixels 
1/2” progressive scan - Monochrome and Bayer mosaic color versions 

61.15 frames/second with full resolution in continuous operation 
Increased frame rate with vertical binning (CM-040 GE) and partial scan 
Exposure time from 54.874μs to 2 sec. using Pulse Width trigger mode 
Programmable exposure from 54,874μs to 16.353ms in Full Frame scan 
Sequence trigger mode for on-the-fl y change of gain, exposure and ROI 
LVAL Synchronous/-asynchronous operation (auto-detect) 
Auto iris lens video output allows a wider range of light 
GigE Vision interface with 10 or 8-bit output 
Programmable GPIO with opto-isolated inputs and outputs 
Comprehensive software tools and SDK for Windows XP/Vista 

www.jai.com

Specifi cations for CM-040 GE / CB-040 GE

Specifi cations CM-040 GE / CB-040 GE

Sensor 1/2” progressive scan CCD
Pixel Clock 33.75 MHz
Frame rate full frame 61.15 frames/second
Active area 6.49 (h) x 4.83 (v) mm
Cell size 8.3 (h) x 8.3 (v) μm
Active pixels 776 (h) x 582 (v)
Color (CB-040 GE) Raw Bayer output, host-based interpolation
Read-out modes

1/2 partial scan

Full

1/4 partial scan

1/8 partial scan
2/3 partial scan
Vertical binning

Region-of-interest (ROI)

776 (h) x 582 (v) 61 fps
776 (h) x 294 (v) 110 fps
776 (h) x 146 (v) 186 fps

776 (h) x 74 (v) 280 fps

776 (h) x 390 (v) 87 fps
776 (h) x 291 (v) 111 fps*

User Definable. Memory read-out

*Note: CM-040 GE only

Sensitivity (CM-040 GE) 0.2 Lux (On sensor, max. gain, shutter off,

50% video)

Sensitivity (CB-040 GE) 1.3 Lux (On sensor, max. gain, shutter off,

50% video)
S/N ratio >50 dB(0 dB gain)
Video output GigE Vision, 8-bit or 10-bit
Auto-iris lens video output 0.7 Vp-p, enabled by internal switch

Gain Manual/Automatic

-3dB to +12 dB

Synchronization Internal X-tal, External hardware

trigger via GPIO

Software trigger via GigE Vision

GPIO Module

Input/output switch

Clock generator (one)

Pulse generators (four)

Configurable 14-in/9-out switch (LUT)

12-bit counter based on 25MHz clock or

Pixel Clock

20-bit counters programmable for length,

start point, end point, repeat

Hardware trigger modes Continuous, Pre-Select,

Pulse Width, Frame delay,

Sequence (Gain, Shutter, ROI)

Electronic shutter

Pre-set shutter

Programmable exposure

Exposure Time (Abs)

Pulse Width

1/60 to 1/10,000 in 10 steps

2L(54.874μs ) to 596L (16.353ms) in 1L steps

μsec – user definable. Same range as PE

max. 2 sec. (can be set by 100μs unit or

Pixel Clock unit)

Control interface Register based

GigE Vision/GenICam compliant

Functions controlled via
GigE Vision interface

Shutter, Gain, Black level, Trigger mode,

Readout mode, GPIO setup, ROI

(GenICam mandatory functions)

GigE Vision streaming
control

Packet size (1428 to 4040bytes),

Delayed (frame) readout, Inter-packet delay,

Indicators on rear panel Power / Hardware trigger, GigE link,

GigE activity
Operating Temperature -5°C to +45°C
Humidity (operation) 20 - 80% non-condensing
Storage temp./humidity -25°C to +60°C / 20 to 80%
Vibration 10G (20Hz to 200 Hz XYZ)
Shock 70G
Regulations CE (EN 61000-6-2, EN-61000-6-3),

FCC part 15 class B, RoHS/WEEE

Power 12V DC +/-10%. 3.6W
Lens mount C-mount

Dimensions (H x W x L) 29 x 44 x 75 mm
Weight 125 g

Connector pin-out

DC In / GPIO

Dimensions

Front view

44

(1.73)

C-Mount

HIROSE HR10A-10R-12PB-01

Side view

Connector Pin-out
Pin 1 GND
2 +12 V DC input
3 Opto in 2(-)*/GND
4 Opto in 2(+)*/Auto iris lens
5 Opto in 1(-)
6 Opto in 1(+)
7 Opto out 1(-)
8 Opto out 1(+)
9 Opto out 2(-)
10 Opto out 2(+)
11 +12V DC input
12 GND

* Pins 3 and 4 can be confi gured
by internal switch selection

14.5

(0.57)

Bottom view

13

(0.51)

5

(0.2)

26

(1.02)

75

(2.95)

59

(2.32)

Caution seal

Serial No.

GigE Vision interface

Accepts RJ-45 with thumbscrews

Rear view

Pin 1 TRD+(0)
2 TRD–(0)
3 TRD+(1)
4 TRD+(2)

5 TRD–(2)
6 TRD–(1)
7 TRD+(3)
8 TRD–(3)

GigE

POWER / TRIG

Spectral Response CM-040 GE Spectral Response CB-040 GE

IR stop

G

R

B

Ordering Information

CM-040 GE 1/2” Monochrome Progressive Scan Camera
CB-040 GE 1/2” Bayer Mosaic Color Progressive Scan Camera

29

(1.14)

6-M3depth4

(depth0.16)

Europe, Middle East & Africa

Phone [phone]
Fax [phone]

Asia Pacifi c

Phone [phone]
Fax [phone]

Visit our web site on www.jai.com

Americas

Phone (Toll-Free) 1 800 445 5444
Phone [phone]

Company and product names mentioned in this datasheet are trademarks or registered trademarks of their respective owners.

JAI A·S cannot be held responsible for any technical or typographical errors and reserves the right to make changes to products and documentation without prior notification.

31000000.12.21.0000