HiHippo AM-1600 CL, AB-1600 CL User Manual
AM-1600 CL / AB-1600 CL
PRELIMINARY
Progressive Scan IT CCD
4872 x 3248 3.3 FPS CL
43.3 mm progressive scan IT CCD (Kodak KAI-16000)
4872 x 3248 resolution @ 3.3 fps
7.4 µm square pixels
12-bit A/D (linear) or 8-bit/10-bit with look-up table (LUT)
Digital Camera Link output and analog output
Automatic dual-channel compensation
Image center partial scan (1624, 812 lines)
User-programmable variable partial scan
2X and 4X binning (V, H, or both)
Synchronous and async trigger modes, with or without pulse width control
Defective pixel compensation
Background subtraction (pixel or area based)
www.jai.com
Pixel gain and offset control (pixel or area based)
Monochrome and RGB color models (internal interpolation)
Specications for AM-1600 CL/AB-1600 CL
1
2
3
4
5
6
9
8
7
11
12
10
Measured without AR
coated cover glass
0.50
0.45
0.40
0.35
0.30
0.25
0.20
0.15
0.10
0.05
0.00
Absolute Quantum Eciency
Wavelength (nm)
300 400 500 600 700 800 900 1000 1100
Measured without AR
coated cover glass
0.50
0.45
0.40
0.35
0.30
0.25
0.20
0.15
0.10
0.05
0.00
Absolute Quantum Eciency
Wavelength (nm)
400 500 600 700 800 900 1000 1100
PRELIMINARY
Specications AM-1600 CL/AB-1600 CL
Sensor 43.3 mm progressive scan IT CCD
Active area 36.1mm x 24.0mm
Active pixels 4872 (H) x 3248 (V)
Cell size 7.4 μm x 7.4 μm
Readout modes A
B
C
U
4872 (H) x 3248 (V) @ 3.3 Hz
4872 (H) x 1624 (V) @ 6.3 Hz (partial scan)
4872 (H) x 812 (V) @ 11.5 Hz (partial scan)
User-denable partial scan
Synchronization Internal/External auto switch
HD/VD, 4.0 V p-p impedance 4.7K Ω
VD= 3.3 Hz ± 2% non-interlace
HD= 10.957 kHz ± 2%
Pixel clock 30.00 MHz
S/N ratio >56 dB
Sensitivity AM-1600
AB-1600
TBD lux f=1.4 (no shutter) @ 3.75 fps,
TBD lux f=1.4 (no shutter) @ 3.75 fps,
Pixel sensitivity: 30μ V/eVideo output Analog
Digital
1.0 Vp-p, 75 Ω
8-bit x 2-tap Base Camera Link
10-bit x 2-tap Base Camera Link
12-bit x 2-tap Base Camera Link
Color (AB-1600 only) Internal Bayer interpolation with RGB output
Gamma Programmable LUT (Gamma 1.0 std)
Shutter speed (programmable) Up to 1/2,700 second in increments of 91.2 μs
Lens mount M42 mount (F-mount optional)
Power 12V DC ± 10%, 800 mA (typical at 25° C)
Operating temperature -10° C to 50° C
Vibration 7 Grms (10 Hz to 2000 Hz) Random
Shock 70 G, 11 ms, half-sine
Dimensions (H x W x L) 55 mm x 55 mm x 120 mm
Weight TBD g (without tripod)
Dimensions
Front view
Rear view
Spectral Response
Connector Pin-out
AM-1600 CL (monochrome)
AB-1600 CL (color)
12-Pin Connector
1 GND (power) 7 TTL in
2 +12V 8 GND
3 GND (analog) 9 Strobe out
4 Video out 10 Trigger in
5 GND (digital) 11 +12V
6 TTL in 12 GND
GUI Interface
A user-friendly GUI (graphical user
interface) is provided. This interface allows
users to control the following functions of
the AM-1600 CL camera:
Shutter control for manual async.
•
and pulse-width control
Gain control
•
Offset Control
•
Save setting s
•
Load settings
•
Repor t settings
•
LUT setting and graphic display
•
Scanning mode selection and option
•
selections
Channel Auto Balancing
•
Camera parameters can be uploaded
from the PC to the camera. Once these parameters are stored in EEPROMs, an
instantaneous change from one setting to another can be done with a delay of
few frames in between.
Software available for download at www.jai.com
Ordering Information
Camera
Side view
Monochrome AM-1600 CL
Color AB-1600 CL
Optional Functions
Internal IR Filter Added OP3-1
Optical Filter Removal OP3-2 (AB-1600 CL only)
Glassless CCD Imager OP21
Glassless UV CCD Imager OP21-UV
F mount OP65-6
Bottom view
Optional Accessories (must be ordered separately)
I/O 26CL-02-26 (2m)
Power Supply PD-12UUP (includes power connector)
Power Supply/2m cable PD-12UU/12P-02S
Europe, Middle East & Africa
Phone +45 4457 8888
Visit our web site on www.jai.com
Fax +45 4491 8880
Asia Pacic
Phone +81 45 440 0154
Fax +81 45 440 0166
Americas
Phone (Toll-Free) 1 800 445 5444
Phone +1 408 383 0300
Company and product names mentioned in this datasheet are trademarks or registered trademarks of their respective owners.
JAI A·S cannot be held responsible for any technical or typographical errors and reserves the right to make changes to products and documentation without prior notication.
10441 Rev 2.05.21.2007
Loading...