Hi G Tek IGIU125PU Users Manual

Programming Unit

IG-IU-125PU

-User Manual-

UM4728 Rev. 2.0

1. Introduction

The Programming Unit is a desktop device that is used to configure the sensors prior
to distribution or installation. The Programming Unit communicates with the sensors
via the low frequency channel (125 KHz). It is externally powered and has RS232
channel to communicate with a PC. The Programming Unit is supplied with
configuration software, which allows reading or writing parameters to the electronic
sensor.

2. Warnings and Cautions

• The Programming Unit required to be connected to a certified power source. In which

the 9VDC output was evaluated as a Limited power source according to UL60950-1
standard 2.5.

• To avoid damaging, please follow the installation instructions under the written order.

The FCC Wants You to Know

This equipment (FCC ID: OB6-IGIU125PU) has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.

This device complies with Part 15 of FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This
device must accept any interference that may cause undesired operation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
a) Reorient or relocate the receiving antenna.
b) Increase the separation between the equipment and receiver.
c) Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
d) Consult the dealer or an experienced radio/TV technician.

FCC Warning

Modifications not expressly approved by the manufacturer could void the user
authority to operate the equipment under FCC Rules.

Instructions concerning human exposure to radio frequency electromagnetic
fields: A distance of at least 20cm. between the equipment and all persons should be

maintained during the operation of the equipment.