Highland 19800 User Manual

Mounting Instructions

1. Attach the two D-rings (supplied) to the

Space Master base with the screws,
washers and locknuts provided, using
the existing holes on each side of the
base.

2. Locate the rear-most tie down rings

mounted to your vehicle (if so
equipped).

3. Position the Space Master on vehicle

floor near the tie down rings.

4. Thread the mounting strap (supplied)

through the Space Master D-ring and
the vehicle tie down ring, as shown.
Wrap the “hook-and-loop” strap back
onto itself to create a secure fit. Repeat
on opposite side.

Cleaning

The Space Master is resistant to most fluids. However,
should a spill occur, remove the Space Master immediately
and rinse with water. Remove heavy soiling by washing with
a mild detergent and warm water.

Congratulations! You have just purchased the unique and
highly functional Highland Space Master vehicle cargo
organizer. Designed for convenience and ease of use, the
Space Master can adapt to most all your storage needs.

Highland Group Industries

31200 Solon Road, Suite 1

Solon, OH 44139

Ph: 440-498-0001

Web: www.highlandusa.com

4

Part No. 30937E Rev. 0

End Panel

Lock Knob

Divider

Parts Diagram

Door

Base

To attach the Grip Pads, peel the
backing from the four pads, and apply
one pad in each corner, as shown,
covering the square hole.

Setup Instructions

1. Place the Space Master in your car trunk
or rear cargo space of your van or SUV.
If you are placing the Space Master in a
van or SUV, follow the Mounting Instruc­tions, listed on the next page, to secure
the organizer to your vehicle.

2. To open, rotate each lock knob one half
turn so the knobs are clear of the doors.

3. Lift the two doors into their upright
position.

4. Rotate the two end panels into their
upright positions. Hint: As you reach the
upright position, lift the end panels slightly
to clear the guides, then press panels into
place.

WARNING: The Space Master vehicle cargo organizer is not
designed for lifting and moving while items are stored inside.
To remove the organizer from your vehicle, first remove its
contents, fold down the divider panels and doors, and rotate
the lock knobs into the locked position. Lift unit from vehicle
by the front handle.

2

5. Lift the divider panels out of the unit and
slide into the grooves located on the panel
doors. You can choose to use both divider
panels, one or none, depending on your
storage needs.

6. To close, simply reverse steps 1-5.

3