Higher Order Innovation 484F49992 Users manual

The remote control is designed to be connected to a computer or mobile device to facilitate control of a
custom video playback service. Follow the steps below to operate the remote.

Bluetooth Operation

1) To connect the remote to your video device, ensure that your device is searching for available

devices.

2) Press any button on the remote to wake it up from sleep.

3) When the device appears on your computer/mobile device begin the connection as indicated.

4) When the connection is confirmed on the video playback device, you will have control of the video

playback via the remote control.

5) Pressing the buttons below will engage that respective feature on the video player
a) FULL – causes the video player to toggle between full screen mode and normal mode
b) PREV – causes the previous video clip to be played
c) NEXT – causes the next video clip to be played
d) REV – causes the video to rewind slowly
e) SLOW – causes the video to move forward slowly
f) REW – causes the video to rewind quickly
g) FF – causes the video to fast forward quickly
h) PLAY – causes the video to either play or pause the ongoing video clip
i) TAG – allows the user to mark a particular video clip for analysis later

6) Pressing the LASER button will cause a laser pointer feature to be enabled. The laser is only turned

on while the button is depressed.

USB Operation

1) Connect the remote to the computer via a USB cable

2) Press a button to wake the remote as needed

3) Pressing the buttons below will engage that respective feature on the video player
a) FULL – causes the video player to toggle between full screen mode and normal mode
b) PREV – causes the previous video clip to be played
c) NEXT – causes the next video clip to be played
d) REV – causes the video to rewind slowly
e) SLOW – causes the video to move forward slowly
f) REW – causes the video to rewind quickly
g) FF – causes the video to fast forward quickly
h) PLAY – causes the video to either play or pause the ongoing video clip
i) TAG – allows the user to mark a particular video clip for analysis later

4) Pressing the LASER button will cause a laser pointer feature to be enabled. The laser is only turned

on while the button is depressed.

The statements should be displayed in the user manual:

changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

-- Consult the dealer or an experienced radio/TV technician for help.