FCC Compliance Statement
FCC Class B Part 15
This device is verified to comply with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment. This equipment has been tested and found
to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not in-stalled and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the
equipment and receiver. Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected. Consult the dealer or an experienced
radio or TGV technician for help.
This equipment complies with the FCC RF radiation exposure limits set forth for an
uncontrolled environment. This equipment complies with the Specific Absorption Rate (SAR)
RF exposure requirements specified in ANSI/IEEE Std. C95.1-1992 and FCC 47 CFR 2.1093
for the General Population/ Uncontrolled Exposure environment when used with a holster for
body worn configuration.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter
1.0 Your New SatPaq
Congratulations. You have purchased a very small, wireless communicator to enhance the
operation of your smartphone from anywhere.
Your SatPaq communicates to satellite 23,000 miles away. The round-trip signal from your
SatPaq to the satellite to our ground station, back to the satellite and then to the SatPaq is
about 100,000 miles. This is half the distance from the earth to the moon. And we do this
with the same transmit power as your phone.
We have designed the SatPaq to be simple and convenient. Just attach to the phone with the
gripper, complete the BlueTooth pairing and you can now text from anywhere. We call this Go
Anywhere Messaging.
2.0 Set-up
Figure 1 - The SatPaq