Highendled YHLL-012-3W-36 Operation Manuals

1 of 2 pages

Operation Manual

HIGHENDLED YHLL-012-3W-36 LED PAR64

3W RGB LED Par has 36pcs LEDs, which is controlled by 3 button, it is MODE, UP, DOWN. It has the

program saving function means that the fixture will keep the same program as the last time when you re-open
the light. The unit has integrated temperature protection, allowing the light to automatically shut off should the
light reach temperatures above 85˚C (181˚F). This allows the unit to cool off in extreme temperatures without
damage and while not affecting other units in operation.

Specifications

• Weight: 5.2 kgs

• Size: 36x29x20CM

• Power input: AC120V/240V 50HZ/60HZ

• Beam angle: 30 degree

• Wattage: 115W

• LEDS: 36PCS 3W (R12,G12,B12)

• 3PIN female DMX XLR socket and 3PIN male DMX XLR socket

• Built-in microphone

• 3 button Digital LED menu

Operating Modes

It has seven kinds of operation mode, they are as follows:
Static color select mode, Color change mode, Color dreaming mode, Auto-run program mode , Sound-active
mode, Slave mode, DMX mode.

2 of 2 pages

Mode Selection

Here above seven kinds running mode are selected by MODE button. Press MODE button and UP button at
the same time, when it is on, you can initialize it at extra factory setting, running on the auto-run program
mode. To make the display stay on all of the time press the MODE and UP buttons at the same time. To make
the display turn off after 20 seconds, press the MODE and DOWN buttons at the same time.

1. Static color select mode

Press “MODE” button, select static color select mode. At this time, the three digital tube displays “C. L.×”,
Press “UP” or “DOWN” to select static colors 0-7 under this mode.

2. Color change mode

Press “MODE” button, select color change mode. At this time, the three digital tube displays “J.××” . Press UP
or DOWN to select the color change speed grade 1-99 under this mode.(From slow to quick)

3. Color dreaming mode

Press “MODE” button, select color dreaming mode. At this time, the three digital tube displays “F.××” . Press
UP or DOWN to select the color dreaming speed grade 1-99 under this mode. (From slow to quick)

4. Auto-run program mode

Press "MODE" button to select the auto-run program mode. At this time, the three digital tube displays "A.- -",
the color change program and color dreaming program run alternatively. Press UP or DOWN button is no use
in this mode.

5. Sound active mode
Press "MODE" button to select the sound active program mode. At this time, he three digital tube displays
"S.××". Press UP or DOWN to select sound-active sensitivity grade 0-31.0 is off sound-active,1 is the lowest
sensitivity,31 is the highest sensitivity.

6. Slave mode

Press "MODE" button to select slave mode. At this time, the three digital tube displays "S.L.A. "Press UP or
DOWN button is no use in this mode.

7. DMX mode

Press "MODE" button to select slave mode. At this time, the three digital tube displays DMX address"×××"
Press UP or DOWN to select DMX address. You can set 512pcs address from 001 to 512.It will be flicker
when there is no controller signal.
DMX MODE: 5 DMX channels

CH NO. VALUE FUNCTION
CH1 000~255 Red (dim→bright)
CH2 000~255 Green (dim→bright)
CH3 000~255 Blue (dim→bright)

000~189 Total dimmer (dim→bright)
190~250

Strobe (slow→fast)

CH4

251~255

No function