HID Global OK5427UE, OK5025CL User Manual

Page 1
Asia Pacific
Europe, Middle East & Africa
Installation Guide
OMNIKEY
®
Smart Card Readers
3121-906-ENEN, B.1
eBase Models: 1021, 3021, 3121, 4040, 4121,
4321, 5021, 5025, 5121, 5125, 5127, 5321, 5325, 5326, 5421, 5427, 6121, 6221, 6321.
Drivers and Manuals:
North America
15370 Barranca Parkway Irvine, CA 92618 USA
Phoenix Road Haverhill, Suffolk CB9 7AE
England
19/F 625 King’s Road North Point, Island East Hong Kong
support.hidglobal.com
© 2010-2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
Page 2
OMNIKEY® Smart Card Reader Installation Guide

Introduction

This guide describes physical behavior and conformities of the OMNIKEY® Smart Card Readers.
1021 USB – Desktop smart card reader in a small form factor for desktop and mobile usage.
3021 USB – High-performance smart card reader, with a USB interface and small form factor for
desktop and mobile usage.
3121 USB – High-performance smart card reader for desktop use with multiple standing base options in a robust housing.
4040 Mobile PCMCIA – High-performance smart card reader for mobile use in laptops and PDAs with PCMCIA interface.
4121 CL - Mobile ExpressCard 34mm – Contactless Reader with ExpressCard™ interface for Laptops and mobile devices that reads/writes to 13.56 MHz smart cards.
4321 Mobile ExpressCard 54 – High-performance smart card reader for mobile use in laptops and mobile devices with the ExpressCard™ interface.
5125 / 5325 USB Prox – Dual interf ace PC-linked reader that reads contactless (125kHz) HID Prox cards and reads/writes virtually any contact smart card.
5121 / 5321 / 5421 USB – Dual interface PC-linked reader that reads/writes to 13.56 MHz contactless cards and virtually any contact smart card.
5127 / 5427 CK/5427 UE USB – Contactless 13.56MHz/125kHz reader with CCID/Keyboard wedge interface.
5021 / 5321 CL USB – Contactless Reader with USB interface for desktop use that reads/writes to 13.56 MHz smart cards.
5025 CL USB – Contactless Reader with USB CCID-compliant interface for desktop use that reads contactless (125 kHz) Prox cards.
5321 CL SAM USB – Dual interface PC-linked reader that reads/writes to 13.56 MHz contactless cards and virtually any SIM-sized contact smart card.
5326 DFR USB – Contactless Dual Frequency (13.56MHz/125kHz) Reader with CCID interface.
6121 Mobile USB – Dongle-sized smart card reader for SIM-sized smart cards, especially well
suited for use with mobile devices.
6221 USB – Dongle-sized reader for SIM-sized smart cards and Micro-SD cards, especially well suited for use with mobile devices.
6321 Mobile USB – Dongle-sized Dual interface PC linked reader that reads/writes to 13.56 MHz contactless smart card and virtually any SIM-sized contact smart card.
Parts
Smart Card Reader
Installation Guide
Find drivers, reader documentation supporting various operating systems at
http://www.hidglobal.com/omnikey.
See the application note for card loading and handling instructions at
http://www.hidglobal.com/omnikey.
2 © 2010-2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
Page 3
Installation Guide OMNIKEY® Smart Card Reader
Operating Temperature
0°-55°C / 32°-131°F
150 cm / 59.1 in - Models 1021, 3021
180 cm / 70.9 in - Other Models
Mean Time Between Failures (MTBF)
500,000 Hours
Host Interfac e
USB 2.0 CCID (USB 1.1 Compatible)
Host Data Transmission Speed
12 Mbps (USB 2.0 Full Speed)
Power Supply
Bus Powered
Operating Temperature
0°-55°C / 32°-131°F
Mean Time Between Failures (MTBF)
500,000 Hours
ExpressCard
54mm
Host Data Transmission Speed
12 Mbps
16 Mbps

Specifications and Installation

For further information, contact HID support: http://support.hidglobal.com/. For driver setup, consult the OMNIKEY Smart Card User Guide.
CAUTION: Install the drivers prior to attaching the OMNIKEY reader with the computer.

USB Connected Reader Specifications

PC Connector Cable
200 cm / 78.7 in - Models 5021, 5025 CL, 5421, 5427 CK

USB Connected Reader Installation

1. Connect the reader with computer; plug the USB connector into your computer’s USB port.
2. When the reader is operational, the LED illuminates.
3. For contactless operation, hold the card next to the reader logo. For contact smart cards, insert the card into the reader with contacts facing up.
4. When the reader is exchanging data with a card (reading/writing), the LED blinks.

PCMCIA and ExpressCard Reader Specifications

4321 4121 CL 4040
Host Interfac e
Power Supply Bus Powered PCMCIA
ExpressCard 34mm PCMCIA

PCMCIA and ExpressCard Reader Installation

1. Insert the reader into the compatible interface slot of your Notebook or mobile device.
2. If the reader is operational, observe the reader in your operating system’s Device Manager.
3. For contactless operation, hold the card next to the logo on the reader. For contact smart cards, insert the card into the reader with contacts facing up.

Regulatory

CAUTION: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
FCC (All Readers)
This device compli es with part 15 of the FCC Rul es. Operation is subj ect to the following two conditions: (1) T his device may not cause harmful interference, and (2) thi s device must accept any interferenc e received, including interference t hat may cause undesired operat ion.
© 2010-2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved. 3
Page 4
OMNIKEY® Smart Card Reader Installation Guide
RFID:13.56 MHz
RFID:13.56 MHz
출력
RFID: 10m에서 24.19mv이하
전원
DC 5
A1D
X-tal
AM
Canada Radio Cert ification (All Readers)
This device compli es with Industry Canada l icense-exempt RSS standard(s). Operation i s subject to the f ollowing two conditions: (1) This d evice may not cause interference, and (2) t his device must accept any interference, including interference that may cause undesired operation of the devic e. Le present appareil est conf orme aux CNR d'Industrie Canada applicable aux appar eils radio exempts de licence. L'exploitati on est autorisée aux deux condit ions suivantes: (1) l'appareil ne doit pas produire de bro uillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi , meme si le brouillage est susceptible d'e n compromettre le fonctionnement .
CE Marking (All Readers)
HID Global hereby declar es that these proximity readers are in com pliance with the essential requirem ents and other relevant provision s of Directive 1999/5/EC. Por el presente, HID Gl obal declara que estos lectores de proxim idad cumplen con los requisitos esenciale s y otras disposiciones relev antes de la Directiva 1999/5/EC. HID Global déclare par l a présente que ces lecteurs à proximit é sont conformes aux ex igences essentielles et aux autres stipulations pertinent es de la Directiv e 1999/5/CE. A HID Global, por meio deste, declara que estes leitores de proximi dade estão em conformidade com as exigências essenciais e outras con dições da diretiva 1999/5/EC. HID Global bestätigt hiermit, dass die Leser die wesentlichen Anf orderungen und anderen relevanten Besti mmungen der Richtlinie 1999/5/E G erfüllen. HID Global dichi ara che i lettori di prossimità sono conformi ai requisiti essenziali e ad altre misure ri levanti come previsto dalla Direttiv a europea 1999/5/EC. Download copies of t he R&TTE Declaration of Conformity (DoC) at http: //www.hidglobal.com/certifi cations
Taiwan (Readers 5321 and 5421)
經型式認證合格之低功率射頻電機,非經許可,公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特 性及功能。低功率射頻電機之使用不得影響飛航安全及干擾合法通信;經發現有干擾現象時,應立即停用,並改善至無 干擾時方得繼續使用。前項合法通信,指依電信法規定作業之無線電通信。低功率射頻電機須忍受合法通信或工業、科 學及醫療用電波輻射性電機設備之干擾。
According to “Admi nistrative Regulations on Low Power Radio W aves Radiated Devices” Without permission granted by the NCC, any company, enter prise, or user is not allowed to change f requency, enhance transmitting power or al ter original characteristic as well as performanc e to an approved low power radio-frequency devi ces shall not influence ai rcraft security and interfere legal communications; If found, the user shall cease operating immediately until no i nterference is achieved. The said legal comm unications means radio communications is operat ed in compliance with the Telecommuni cations Act.
The low power radio-frequenc y devices must be suscept ible with the interference from legal communications or ISM radio wave radiated devi ces.
.
Japan MIC (Reader 4121)
この装置は総務省の型式指定を受けています。
本製品は電波を使用したRFID機器の読み取り・書き込み装置です。
そのため使用する用途・場所によっては、医療機器に影響を与える恐れがあります
Korean KC (Readers 1021, 3121, 4040, 4321, 5021, 5325, 5326, 5421, 6121, 6221,
6321)
항목 규격 송신주파수 수신주파수
전파형식 발진방식 변조방식
4 © 2010-2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
Loading...