HID Global ER40C User Manual
Edge
DRAFT
15370 Barranca Parkway
Irvine, CA 92618-2215
USA
Edge is the next evolution in access control hardware solutions. A true IP solution that meets the demands of open architecture, IP-centric
environments, Edge provides fully distributed intelligence and decision making right to the door, leveraging the IT infrastructure to the
maximum extent possible. Wire the Edge device to Hi-O interface modules to provide connectivity to electronic door components and
access control readers.
Hi-O involves devices with built-in intelligence and a CANbus that links all the devices together. Hi-O CANbus data trafc can be password
protected and encrypted, or both. Each Hi-O device (such as the push plate, electric strike, card reader, door operator) is connected to the
CANbus by a single, four-wire cable. Two of the wires supply power and the other two are used for data communication.
EdgeReader® and EdgePlus®
Models: EH400, EHR40, EHRP40, EH400-K
ER40C, ERP40C
InstallatIon GuIde
82000-920, Rev A.1
December 10, 2009
© 2009 HID Global Corporation. All rights reserved.
Specications
CONNECTION PARAMETER CONDITIONS VALUE
Voltage - Nominal - 48 VDC
PoE Power
(input)
+DC (input)
CAN PWR
(output)
Current - Normal Standby
Condition (NSC)
Current - Maximum CAN PWR - max load 275 mA
Voltage - 12 VDC - 24 VDC
Current - Normal Standby
Condition (NSC)
Current - Normal Standby
Condition (NSC)
Current - Maximum 12 VDC 2.2 A
Current - Maximum 24 VDC 2.1 A
Voltage - Nominal PoE 24 VDC
Current - Maximum PoE 300 mA
Voltage - Nominal + DC + DC
Current - Maximum + DC 2 Amp - AUX limited
CAN PWR - not loaded 75 mA
12 VDC
CAN PWR disconnected
24 VDC
CAN PWR disconnected
190 mA
110 mA
OPERATING
TEMPERTURE
32° - 122°F
(0° - 50° C)
CABLE LENGTH
Hi-O CAN Bus
= 75 ft (23 m) - 18 AWG ● 1.02mm ● 0.82mm
RJ45 = 328 ft (100 m) - Category 5 K
= 30 ft (9 m) - 22 AWG ● 0.65mm ● 0.33mm
2
2
EdgeReader and EdgePlus
DRAFT
EH400, EHR40, EHRP40, EH400-K
Mounting
Wiring
EdgeReader and EdgePlus
82000-920 A.1
Junction box not included.
Hi-O Device
CAN Termination
Resistor
(Default - IN)
Ethernet
Activity LED
3.3 VDC LED
CAN-LO (Brown)
CAN-HI (White)
GND (Black)
CAN PWR (Red)
GND
DC In
Ethernet / PoE
Auto-Detected
ATTENTION
Observe precautions for handling
ELECTROSTATIC SENSITIVE DEVICES
INSTALLATION GUIDE
2
©2009 HID Global Corporation. All rights reserved.
Loading...