HID Global 0006A User Manual

REV DESCRIPTION DATE APPROVED

D REVISED PER EO #E5395-15

NOTE: Cover sheet is for Revision Control on ly, and is not to be sent with document.

REV

SHEET 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 59 50 51

REV

SHEET 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33

REV STATUS DDDD

OF SHEETS 0123456789101112131415

TOLERANC ES APPROVALS DATE HID CORPORATION
.XX = +/- .03” DWN E. DeQuiroz 081597 IRVINE, CALIFORNIA
.XXX = +/- .010” CHK GRIFFIN 082297 Installation Manual,

°

ANGLES = +/- 1

APVD OKUDA 082297 ThinLine II Reader
MATERIAL N/A APVD SIMPSON 082297
FINISH N/A P/N 5395-902 REV D
SCALE N/ A

THIS DOCUMENT CONTAINS PROPRIETARY

I NFO RMATION. IT MAY NOT BE DISCLO SED TO

OTHERS OR USED FOR MANUFACTURING

PUR POSES WITHOUT T HE PERMISSION OF HID

CORPORATION.

SIZE A SHEET 0 OF 3

Install Manual – 5395-902 Rev D
ThinLine IITM Installation Manual

_____________________________________________________________________________________________________

HID Corporation 9292 Jeronimo Road Irvine, CA 92618-1905 USA TEL [phone] [phone] FAX [phone]
Web page, E-mail - www.hidcorp.com - ThinLine II Installation Manual 5395-902 Rev D 1 of 3

PARTS LIST ( Included)
Quantity

- THINLINE IIM Reader with snap-on cover and 18”
cable

1

- #6-32 x 1” self- t apping panhead screw

2

- Installation manual

1

Connecting the Reader to the Host

Connect the reader to the host according to the wiring
table below and the host installation guide.

Wiegand

Clock & Da ta

Wir e Co lo r

+DC
+DC

Red

PARTS LIST ( Not - Included)
Quantity

- Wire splice

9

- DC Power supply 5.0 VDC or 12 VDC

2

Mounting Instructions

Determine an appropriate mounting location. The

•

reader may be mounted to any surface, including
metal.

Drill t wo (2 ) 3/3 2-inch (2 .5mm) holes approximately

•

1 inch deep for mounting the reader.

Drill a 5 /8- inch (16 mm) hole for the cable .

•

Remove the snap-on cover from the reader and

•

secure the reader to t he mounting surface.

Route the cable from the reader and/or power

•

supply to the host. A linear type power supply is
recommended. Check all electrical codes for pr oper
cable installation.

For best operation, the drain wire should be

•

disconnected at t he power supply end of the cables.

For the cable connection to the Panel - Use Alpha

•

#1299C or equivalent.

Test the operation of the reader. After completion of

•

the test, r eplace t he snap-on cover.

See sheet 3 of this manual for the appropriate

•

dimensioned draw ings.

Ground
Ground

Black

Data0

Data

Green
Data1

Clock
White

Shield Gr o und
Shield Gr o und

Drain

Green LED
Green LED

Orange

Red LED
Red LED

Brown

Beeper
Beeper

Yellow

Hold
Hold
Blue

---

Card Present

Violet

Te sting a nd Operation

_____________________________________________________________________________________________________

HID Corporation 9292 Jeronimo Road Irvine, CA 92618-1905 USA TEL [phone] [phone] FAX [phone]
Web page, E-mail - www.hidcorp.com - ThinLine II Installation Manual 5395-902 Rev D 2 of 3

When power is applied to the reader the LED will

•

flash green three (3) times while the beeper beeps
simultaneously. The LED will then turn red. This
indicates that the microcontroller is operating
properly.

Present an ID card to the reader. The LED will

•

momentarily turn green while the beeper beeps
once, indicating that the card was read successfully.

Important Product Specifications

Power requirements (linear supply)

Operat ing Voltage Range 5.0 – 16. 0 VDC
Absolute Maximum Voltage 18 VDC
Peak Current 80 Ma
Average Current 5V or 12V 20 Ma

Maximum cable distance 500 ft ( 153 m)
To host

FCC Compliance S t a tement:

This device co mplie s w ith
part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept
any interference received, including interference that
may cause undesired operat ion.

_____________________________________________________________________________________________________

HID Corporation 9292 Jeronimo Road Irvine, CA 92618-1905 USA TEL [phone] [phone] FAX [phone]
Web page, E-mail - www.hidcorp.com - ThinLine II Installation Manual 5395-902 Rev D 3 of 3

Front, side, and back view

Figure 1

_____________________________________________________________________________________________________

HID Corporation 9292 Jeronimo Road Irvine, CA 92618-1905 USA TEL [phone] [phone] FAX [phone]
Web page, E-mail - www.hidcorp.com - ThinLine II Installation Manual 5395-902 Rev D 4 of 3