HF Scientific M100+ Quick Start Guide

Quick Start Guide

Item

Quantity

(shipped in a separate box to ensure freshness)

M100+TM Laboratory Turbidimeter

Models 28060 & 28061

Unpacking and Inspection:

The table below indicates the items in the turbidimeter shipment.

M100+ Laboratory Turbidimeter

Accessory Kit for M100+ (2 empty sample cuvettes with caps)

Full Range Calibration Kit: High Range A, High Range B, 1000 NTU,
10 NTU & 0.02 NTU

Quick Start Guide

Flash Drive Containing Full Owner’s and User’s Manual

Wall Mount Power Supply with Ferrite

A ferrite is included with the power supply. This should be looped twice
through the cord near the side that connects to the instrument to eliminate EMI
interference.

Remove the instrument from the packing carton. Carefully inspect all items
to ensure that no visible damage has occurred during shipment. If the items received
do not match the order, please immediately contact the local distributor or the HF
scientific Customer Service department.

1

1

1

1

1

1

Power Requirements:

• The M100+ requires 12VDC for proper operation. The provided supply
is rated at 1A.

• The M100+ is supplied with a wall mount power supply intended for
operation with 100-240 VAC, 47-63 Hz power source. Before

installing, verify that the line voltage falls within these
specifications.

• Connect the wall mount power supply to the rear panel of the M100+.

• An optional Euro wall mount power supply is available.

M100+ Quick Start Guide
29296 Rev 1.1 11/18

Turn Power “ON:”

After confirming that the M100+ is safely and properly plugged into a suitable

stay on and require a manual shut down. An On/Off button will

premature degradation of the lamp. The

If you

Power Supply

Touchscreen

Standard Inserted in Optics

USB Connector

power source, the instrument may turn on. If the instrument does not turn on,
simply touch the screen. Depending on the setting, the instrument will usually
power down automatically.

There is a setting (Auto Power Down) that allows the instrument to

appear on the Home screen. It is not recommended to leave the instrument on
constantly as it may cause drift and
drift can be corrected by more frequent calibrations.

For complete instructions refer to the full manual on the included flash drive.
have any further questions you can contact HF scientific by using one of the methods
noted below.

3170 Old Metro Parkway

Fort Myers, Florida 33916-7597

Phone: [phone] Fax: [phone]

Toll-free: 888-203-7248

Email: [e-mail]

www.hfscientific.com

M100+ Quick Start Guide
29296 Rev 1.1 11/18