Hewlett Packard Enterprise WL606 User Manual

Table of Contents

Appendix A Regulatory Information........ 1

General Statements................................. 1

US – Radio Frequency Requirements ..... 1

US Federal Communications Commission (FCC) 1

Industry Canada – RF Compliance.......... 1

Safety Compliance Notice........................ 2

EU Compliance........................................ 2

EU – Restrictions for Use in the 2.4GHz band 4
EU – Restrictions for Use in the 5GHz band 4

Brazil RF Compliance.............................. 5

Korea RF Compliance.............................. 5

Taiwan regulatory statement.................... 5

WEEE Directive–2002/96/EC .................. 6

i

Appendix A

General Statements

The 3Com Wireless Dual Band 11n USB Adaptor (3CRUSBN275; M/N: WL-606) must be installed and used in strict

accordance with the manufacturer’s instructions as described in the user documentation that comes with the product.

This product contains encryption. It is unlawful to export out of the U.S. without obtaining a U.S. Export License.
This product does not contain any user serviceable components. Any unauthorized product changes or modifications

will invalidate 3Com’s warranty and all applicable regulatory certifications and approvals.

This device generates and radiates radio-frequency energy. In order to comply with FCC radio frequency radiation
exposure compliance requirements, a separation distance of at least 2.5 cm (1.0 inch) must be maintained between the
antenna of the device and all persons.

The installer of this radio equipment must ensure that the antenna is located or pointed such that it does not emit RF
field in excess of Health Canada limits for the general population; consult Safety Code 6, obtainable from Health Canada’s
website www.hc-sc.gc.ca/rpb.

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. End users must
follow the specific operating instructions for satisfying RF exposure compliance. This equipment should be installed and
operated with minimum distance 2.5cm between the radiator and your body.

This product must maintain a minimum body to antenna distance of 2.5 cm. Under these conditions this product will
meet the Basic Restriction limits of 1999/519/EC [Council Recommendation of 12 July 1999 on the limitation of exposure of
the general public to electromagnetic fields (0 Hz to 300 GHz)].

Regulatory Information

: Exposure to Radio Frequency Radiation

US – Radio Frequency Requirements

This device must not be co-located or operated in conjunction with any other antenna or transmitter.

This device is for indoor use only when using channels 36, 38, 40, 44, 46 or 48 in the 5.15 to 5.25 GHz frequency
range.

High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands. These radar
stations can cause interference with and/or damage this device.

US Federal Communications Commission (FCC)

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.

Changes or modifications not expressly approved by 3Com could void the user’s authority to operate this equipment.

The USB dongle transmitter is approved for use in typical laptop computers. To comply with FCC RF exposure
requirements, it should not be used in other devices or certain laptop and tablet computer configurations where the USB
connectors on the host computer are unable to provide or ensure the necessary operating configurations intended for the
device and its users or bystanders to satisfy RF exposure compliance requirements.

These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

Industry Canada – RF Compliance

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conform à la norme NMB-003 du Canada.

This device complies with RSS 210 of Industry Canada.

Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of this device.

1

L ‘ utilisation de ce dispositif est autorisée seulement aux conditions suivantes: (1) il ne doit pas produire de brouillage
et (2) l’ utilisateur du dispositif doit étre prêt à accepter tout brouillage radioélectrique reçu, même si ce brouillage est
susceptible de compromettre le fonctionnement du dispositif.

The term "IC" before the equipment certification number only signifies that the Industry Canada technical
specifications were met.

To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (EIRP) is not more than that required for successful communication. To prevent
radio interference to the licensed service, this device is intended to be operated indoors and away from windows to provide
maximum shielding. Equipment (or its transmit antenna) that is installed outdoors is subject to licensing.

Pour empecher que cet appareil cause du brouillage au service faisant l'objet d'une licence, il doit etre utilize a
l'interieur et devrait etre place loin des fenetres afin de Fournier un ecram de blindage maximal. Si le matriel (ou son
antenne d'emission) est installe a l'exterieur, il doit faire l'objet d'une licence.

High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands. These radar
stations can cause interference with and/or damage this device.

IMPORTANT NOTE:
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. End users must follow

the specific operating instructions for satisfying RF exposure compliance. To maintain compliance with IC RF exposure
compliance requirements, please follow operation instruction as documented in this manual.

Safety Compliance Notice

This device has been tested and certified according to the following safety standards and is intended for use only in
Information Technology Equipment which has been tested to these or other equivalent standards:

■ UL 60950-1

■ CAN/CSA C22.2 No. 60950-1

■ IEC 60950-1

■ EN 60950-1

EU Compliance

This equipment may be operated in

AT BE CY CZ DK EE FI FR
DE GR HU IE IT LV LT LU
MT NL PL PT SK SI ES SE
GB IS LI NO CH BG RO TR

Intended use: IEEE 802.11a/b/g and 802.11n Draft 2.0 radio LAN device

Česky
[Czech]

Dansk
[Danish]

Deutsch
[German]

3Com Coporation tímto prohlašuje, že tento
RLAN device je ve shodě se základními
požadavky a dalšími příslušnými ustanoveními
směrnice 1999/5/ES.

Undertegnede 3Com Corporation erklærer
herved, at følgende udstyr RLAN device
overholder de væsentlige krav og øvrige
relevante krav i direktiv 1999/5/EF.

Hiermit erklärt 3Com Corporation, dass sich
das Gerät RLAN device in Übereinstimmung
mit den grundlegenden Anforderungen und
den übrigen einschlägigen Bestimmungen der
Richtlinie 1999/5/EG befindet.

2