Hewlett Packard Enterprise StoreOnce 3620, StoreOnce 3640 Start Here Manual

HPE StoreOnce 3620 and
3640 Systems Start Here

Use this guide when installing a basic system without
optional storage products and with all PCIe cards pre­installed. PCIe cards that were ordered with the system
are pre-installed.

Use the HPE StoreOnce 3620, 3640, 5200, 5250, and
5650 Systems Installation Guide in the following cases.

• The system includes optional storage products or
capacity upgrade kits.

• The system arrived without PCIe cards pre-installed
or requires additional PCIe cards.

Guide

Abstract

This guide describes how to install a basic HPE
StoreOnce 3620 or 3640 System that does not include
optional storage products. The StoreOnce System can
then be fully configured using the StoreOnce
Management Console, as described in the HPE
StoreOnce 3620, 3640, 5200, 5250, and 5650 Systems
Installation Guide.

Process overview

Required tools:

• Torx T25 screwdriver

• A monitor and USB keyboard or a KVM for initial
network configuration

Procedure

1. Verify the contents

2. Record the iLO default network information

3. Install the components in the rack

4. Attach the security bezel

5. Connect the system cables

6. Power up

7. Configure iLO during bootup (optional)

8. Configure the basic network

9. Configure the StoreOnce System

©

Copyright 2018 Hewlett Packard Enterprise Development LP

Part Number: BB954-80005
Published: September 2018
Edition: 1

*BB954-80005*

Verifying contents

Procedure

1. Verify that you received the following items:

• StoreOnce System

• Rail kit

• Security bezel

Page 1

• Two power cables

• Two network cables

Recording the iLO default network
information

Procedure

Record the iLO default network information from the
label on top of the server node.

iLO user name:________________________

iLO network name:_____________________

iLO password:_________________________

Installing the server in the rack

CAUTION: Use extreme caution when installing

and pulling units from the rack. Unattached units
can slip and fall, damaging the StoreOnce System
or causing personal injury. Hewlett Packard
Enterprise is not responsible for any damage or
injury caused by mishandling the StoreOnce
System.

Always use at least two people to lift and locate an
enclosure into the rack.

Procedure

1. Install the rail kit for the StoreOnce server. See the

installation instructions that ship with the rail kit.

2. Insert the two locking nuts for the server into the rack;
one on each front column.

3. Install the server into the rack and secure it using the
thumbscrews on the front bezel of the server.

2. Lock the bezel.

The key to lock the bezel is attached to the back of
the security bezel. One key is supplied.

Connecting the system cables

Procedure

1. Connect the power cables.

Connect each power cable to a separate PDU in the
rack.

2. Connect a network cable to LAN port 1.

3. Connect a network cable to the iLO port

(recommended).

Attaching the security bezel

Procedure

1. Insert the security bezel right tab into the slot on the

chassis and then rotate the bezel to close.

4. If you are not using iLO for initial configuration,
connect a VGA monitor and a USB keyboard.

Powering on the system

Prerequisites

All storage enclosures must be installed and cabled
before the system is powered on. For instructions about
installing optional storage enclosures, see the HPE

StoreOnce 3620, 3640, 5200, 5250, and 5650 Systems
Installation Guide.

Page 2