Hewlett Packard Enterprise MRLBB0801 User Manual

MSM317 Access Device Installation Guide

The MSM317 Access Device is a
wireless/wired end-point solution with
an integrated four-port (plus uplink)
managed Ethernet switch that can be
installed in a standard NEMA-WD6
(US) or BS 4662 (International)
electrical outlet box.

It provides a complete connectivity
solution for hospitality or multiple
dwelling unit applications, supporting
a variety of IP-based in-room
applications over a single wire.

NEMA-WD6 Version
(J9422A)

BS 4662 Version
(J9423A)

This guide describes how to physically install the MSM317 in an electrical outlet box
and make all necessary power and network connections. This guide assumes that
before installing the MSM317, all configuration issues have been addressed as
described in the MSM317 Access Device Installation and Getting Started Guide
available at: www.procurve.com/customercare/support/manuals/index.htm.

Package contents

• MSM317 body

• Two faceplates (NEMA-WD6 and BS 4662)

• Two trim panels (NEMA-WD6 and BS 4662)

• Two mounting screws

•This guide

Professional installation required

Professional installation of the MSM317 is required for proper RF operation and compliance.
Please consult with a professional installer who is trained in RF installation and knowledgeable
about local regulations (including building and wiring codes) to ensure that the MSM317 is
operating in accordance with channel, power, indoor/outdoor restrictions and license
requirements for the intended country of operation.

Safety information

Take note of the following safety information during installation of the MSM317:

• If your network covers an area served by more than one power distribution system, be sure
all safety grounds are securely interconnected.

• Network cables may occasionally be subject to hazardous transient voltages (caused by
lightning or disturbances in the electrical power grid).

• Handle exposed metal components of the network with caution.

• This product does not have a power switch. It is powered-on when the Uplink port is plugged
into a PoE power source.

2 MSM317 Access Device Installation Guide

Faceplate Trim Panel

MSM317 Body

NEMA-WD6 Version

BS 4662 Version

• This product and all interconnected equipment must be installed indoors within the same
building, including all associated network connections as described by Environment A of the
IEEE 802.3af standard.

• It is normal for the rear metal cover of the MSM317 to get hot during operation. The cover is a
heat sink and is used to dissipate the heat generated by the MSM317.

MSM317 connectors and status lights

MSM317 components