Hewlett Packard Enterprise APINM210 User Manual
Aruba APM-210 Wireless Access Point Module
Regulatory Compliance and Safety Information User Guide
Introduction
This document contains domestic and international regulatory compliance and safety information for the access point
module. To ensure that this device complies with the regulatory standards for your region, please refer to the sections
below.
“Electrical and Environmental Specifications” on page 1
“Proper Disposal of Aruba Equipment” on page 1
“Safety and Regulatory Compliance” on page 2
Electrical and Environmental Specifications
Ethernet:
Power:
o
1x 10/100/1000 auto-sensing Ethernet RJ-45 Interface
o
MDI/MDX
o
IEEE 802.3 (10Base-T), IEEE 802.3u (100Base-T). IEEE 802.3ab (1000Base-T)
Power over Ethernet (IEEE 802.3at and 802.3af compliant), 48V DC (nominal) and 56V DC
o
(maximum)/350mA (see
o
48 VDC power interface, supports powering through an AC-to-DC power adapter
o
POE support on Ethernet ports: 802.3at-compliant and 802.3af-compliant POE sourcing devices
o
Connect Only to IEC 60950-1 or IEC 60601-1 3
rd
edition products and power sources.
Environmental
o
Operating:Temperature:
o
0° C to +50° C (+32° F to +122° F)
o
Humidity: 5% to 95% non-condensing
Storage and transportation:
o
o
Temperature: -40° C to +70° C (-40° F to +158° F)
For additional specifications on this product, please refer to the data sheet. The data sheet can be found at
www.arubanetworks.com
Proper Disposal of Aruba Equipment
Environmental Compliance and Aruba products, see our website a
Dispose of Aruba products per local regulations. For the most current information about Global
t www.arubanetworks.com.
Safety and Regulatory Compliance
Aruba Networks provides a multi-language document that contains country-specific restrictions and additional safety
and regulatory information for all Aruba access points. This document can be viewed or downloaded from the
following location:
www.arubanetworks.com/safety_addendum
Regulatory Model Names
The following regulatory model names apply:
o
FCC
APINM210
The host device label is required to state the following:
Contains FCC ID: Q9DAPINM210
Contains IC: 4675A-APINM210
The following Caution statement is required in the user manual:
Loading...