HES KP20 User Manual
Instruction Manual
HES KP20 (12-button keypad) stand-alone cabinet lock
Package contents
1
One (1) HES KP20 cabinet lock
2
One (1) Rubber washer
One (1) M6 nut
3
One (1) Flat and one (1) Offset Locking Cam
4
Two (2) M4 washers
5
Five (5) Pan Head Phillips Screws
6
6-1
M4 x10mm locking cam screw
6-2
M4 x10mm (1-5mm thick door)
M4 x 20 mm (10-15mm thick door)
M4 x 25 mm (15-20mm thick door)
M4 x 30 mm (20-25mm thick door)
※
Power : 4.5V (Alkaline AAA 1.5V x 3)
Public Mode (One -time Use)
Lock the door
a
Sol-Do~
b
Flashes
3 times
(ex : 1 2 3 4) (ex : 1 2 3 4) (ex : 1 2 3 4)
Close the cabinet door and enter your passcode
a
- this is confirmed by three red flashes followed
by a standard beep ( Sol-Do~)
Rotate the knob to the locked position
b
Passcode length
4 Digit
5 to 12 Digits
How to configure
Press any four digits
Press + 5 to 12 Digits +
*
#
Hardware installation
6-2
5
-Risk of explosion if battery is replaced
by an incorrect type.
1
2
Private Mode (On-going Use)
Unlock the door Unlock the door Lock the door
a
Do-Mi-Sol~
b
Flashes
3 times
Enter the passcode you used to lock the door
a
-this is confirmed by three yellow flashes followed
by a long beep (Do-Mi-Sol~)
Rotate the knob to the unlocked position
b
and open the door
※ Public Mode (One-Time use)
- Previously used passcode will be erased
after unlock and stay open for next user.
a
b
문을 열때
a
Enter the registered pass code
-this is confirmed by three yellow flashes followed
by a long beep (Do-Mi-Sol~)
Rotate the knob to the locked position
and open the door
Do-Mi-Sol~
b
Flashes
3 times
-Please only use new alkaline batteries.
6-1
5
4
3
문을 잠글 때
Flashes
3 times
Close the door and turn the knob
a
to the locked position
-this is confirmed by three red flashes followed
by a standard beep (Sol-Do~)
b
The cabinet lock will automatically lock in 3 seconds
※ Private Mode (On-going Use)
- when the knob is rotated to the locked position
the cabinet lock will lock in 3 seconds.
Caution
LED Feedback
-Red
-Yellow
-Amber
Audio Feedback
Short Beep - "Beep-"
Std. Beep - "Sol-Do~"
Long Beep - "Do-Mi-Sol~"
Sol-Do~
a
Using the Master Code
Important Note
Two c ode le vels
Master
Code
Step 1 Step 2
· Factory Master Code
“ 3 5 2 6 ”
An existing user code is deleted
when a valid Master Code is
entered.
The User Code will need to be set
again during programming of
private mode.
User
Code
Ø13/64"
(5 mm)
Do-Mi-Sol~
Beep-Beep-Beep-Beep-Beep-
Flashes
5 times
a
b
(ex : # 3 5 2 6 #)
a
Press + “Master Code” +
- Listen for extended beep
- Unlock the lock with short beep 5x followed by 5x
flashing Red LED's
b
Rotate the knob to the unlocked position and
open the door.
5-5/64" (129 mm)
Emergency Power
St ep 1
a
Do-Mi-Sol~
Sol-Do
b
b
Flashes
5 times
Connect a standard 5 pin Micro USB cable to
a
the USB port on the right side of the lock
When power is applied, both LED's flash
b
5x followed by an extended beep
Step 2
c
Enter a valid User Code or Master Code to unlock
c
the cabinet
-An existing user code is deleted when a valid
Master Code is entered.
-The User Code will need to be set again during
programming of private mode.
d
Open the door and change the batteries
d
Ø11/16"
(17 mm)
Installation Template
Change the User Code
Change a User Code with a registered Master Code (Private Mode)
Step 1
#
(for 4 secs)
Beep~
Flashing
for 8 secs
a
a
#
Pres s button for 4 s ecs
- F las hing Yello w L ED' s f or 8
seconds followed by a short beep
Change a User Code with a registered User Code
Step 2 Step 3 Step 4 Step 5
#
Enter
Master Code
Enter registered Master Code
b
c
#
Pres s button
- F las hing Yello w L ED' s f or 8
second s f ollowe d by a long beep
Ra-Si~
Flashing
for 8 secs
d
Enter new
User Code
Enter new User Code
#
Do-Re-Mi~
Flashing
for 8 secs
Pres s button
#
e
- 5 x flashing Red LED's f ollowe d
by an e xtended beep
-New User Code successfully
registered
Exampl e)
· Master code : 3 5 2 6
· New User code : 3 3 3 3
# (for 4 seconds)
→
3 5 2 6 #
3 3 3 3 #
Step 1 Step 2 Step 3 Step 4 Step 5
*
(for 4 secs)
Beep~
Flashing
for 8 secs
Press for 4 secs.
a
*
- F las hing Yello w L ED' s f or 8
seconds followed by a short beep
Enter re gist ered Us er C ode
b
Change the Master Code
Step 1 Step 2
#
(for 4 secs)
Beep~
Flashing
for 8 secs
#
a
Pres s button for 4 s ecs
- F las hing Yello w L ED' s f or 8
seconds followed by a short beep
Enter registered “Master Code”
b
Enter
“Master Code”
Enter
User Code
Pres s button
c
- F las hing Yello w L ED' s f or 8
second s f ollowe d by a long beep
Step 3
Pres s button
c
*
- F las hing Yello w L ED' s f or 8
seconds followed by a short beep
* *
(1 tim e)
Enter
User Code
# (for 4 seconds) 3 5 2 6 * 5 5 5 5 # 5 5 5 5 #
→
*
Ex ample)
Ra-Si~
Flashing
for 8 secs
Enter new User Code
d
· Current Master code : 3 5 2 6
· New Master code : 5 5 5 5
Step 4 Step 5 Step 6 Step 7
*
(1 tim e)
Flashing
for 8 secs
Ra-Si~
d
Enter new
“Master Code”
Enter new “Master Code”
Pres s button
e
- F las hing Yello w L ED' s f or 8
seconds followed by a short beep
How to set other functions of HES KP20
Enter registered Master Code; an existing user code is deleted when a valid Master Code is entered
(1 tim e)
Do-Re-Mi~
Flashes
5 times
Pres s button
e
*
- 5x flashing Red LED's followed by
an ex tended beep
-New User Code successfully registered
#
(1 tim e)
Ra- i~
Flashing
for 8 secs
#
Enter New “Master Code”
f
one mor e time
Exampl e)
예시 )
· Current User code : 3 3 3 3
· New User code : 4 4 4 4
* (f or 4 second s)
→
3 3 3 3 *
4 4 4 4 *
Enter new
“Master Code”
ag ain
g
Pres s button
-5x flashing Red LED's followed by
an ex tended beep
-New Master Code successfully registered
(1 tim e)
#
#
Do-Re-Mi~
Flashes
5 times
How to switch between Public & Private Mode
문을 열때
Private Mode Public Mode
#
Sol-Do~
1
#
+
(for 4 s ecs)
a
0
0
+
a
a
Flashes
3 times
1
Press , and buttons
simultaneously for 4 seconds
- 3x flashing Yellow LED's followed by a
long beep
문을 잠글 때
a
Flashes
2 times
1
Press , and buttons
simultaneously for 4 seconds
- 2x flashing Red LED's followed by a
long beep
Sol-Do~
1
(for 4 s ecs)
0
#
0
#
+
+
a
How to turn Melody Sound On / Off
문을 열때
Turn on the sound
a
Flashes
3 times
1
Press , and buttons
a
simultaneously for 4 seconds
- 3x flashing Yellow LED's followed by a
long beep
#
Sol-Do~
1
#
+
(for 4 s ecs)
a
8
8
+
Turn off the sound
문을 잠글 때
a
Flashes
2 times
#
1
Press , and buttons
aa
simultaneously for 4 seconds
-2x flashing Red LED's followed by a
long beep
※ FCC statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
※This appliance and its antenna must not be co-located or operation in conjunction with any other antenna or transmitter.
This equipment should be installed and operated with minimum distance 20cm between the radiator& your body.
Ra-Si~
1
#
+
(for 4 s ecs)
a
8
8
+
ELECTRONIC SECURITRY HARDWARE
HES | Securitron
assaabloyesh.com | 800.626.7590 | 10027 S. 51st Street Phoenix, AZ 85044 USA
Document #3080006.013 Rev. 1
Loading...