HermanMiller Nelson Installation Instructions Manual

HermanMiller

The Collection

Nelson

How to assemble
your table.

For more information about our products and services or to see a list of dealers, please visit us at

hermanmiller.com or call [phone].

© 2017 Herman Miller, Inc., Zeeland, Michigan Printed in U.S.A. Part No. 1b2wcy - E.

TM Y, Nelson are among the trademarks of Herman Miller, Inc.

TM

Table Installation Instructions

Parts Included

Round - Top Surface Rectangular - Top Surface

For Rectungalur Table:

Tools Required

M5 Allen Wrench 3/16” Allen Wrench

Step 1

1.1

Lay table face down on padded clean surface.

Leg (qty:2) Stretcher

Joint Connector (qty:4)

1/4-20 Screw (qty:32)

For Round Table:

Leg (qty:4)

Step 2

2.1

Remove blue plastic netting on legs, prior to affixing table base to leg. (Screw holes will
not match up unless this is done first.)

2.2

Assemble stretcher(s) to legs. Tighten joint connectors (male and female) using two allen
wrenchs.

(For round surface)

Stretcher (qty:2) Joint Connector (qty:8)

1/4-20 Screw (qty:32)

HermanMiller Eames® Table Assembly Instructions1

Step 2

Step 3

(For round surface)(For rectangular surface)

2.1

Assemble stretcher(s) to legs. Tighten joint connectors (male and female) using two allen
wrenchs.

3.1

Align holes in legs with holes in table top.

Step 3

3.1

Align holes in legs with holes in table top as shown (alternating screw assembly).

(For rectangular surface)

HermanMiller Eames® Table Assembly Instructions2