HermanMiller Verus, Lino Adjustment Manual

HermanMiller

Verus

™

Chair

Seat Height: Paddle-shaped lever on right side

Seat Depth: Lever under right side of seat

Only available on some models.

To raise:

While taking your weight o chair,
li lever up.

To lower:

While seated, li lever up.

At the proper height, your feet should rest flat on the floor.

In the proper position, you will have approximately three-ngers of clearance

between the back of your knees and the seat edge.

Tilt Tension: Long stem on right side with knob Tilt Limiter: Knob below le side of seat

Available on most models.

To increase tension:

While seated, turn knob forward
(toward + sign).

To increase depth:

Pull lever out, slide thighs forward to
adjust seat; release lever.

To decrease depth:

Pull lever out, push seat back and
release lever.

To limit tilt range:

Turn counterclockwise to limit the level
of recline

To decrease tension:

While seated, turn knob backward
(toward – sign).

There are six positions on the tilt tension knob.

Set the tilt tension to control the resistance you feel when leaning back.

For the Semi Synchronous tilt with Tilt Limiter, the tension is pre-loaded to

adjust to the user.

To release tilt limiter:

Turn clockwise to increase the level
of recline

There are ve positions on the tilt limiter knob.

Engage the tilt limiter when you want to sit in an upright or partially

reclined position.

Adjustment Guide1HermanMiller Verus™ Chair

Forward Tilt: Front paddle on le side of seat

Only available on some models.

To position chair forward:

Turn paddle forward, then recline fully.
An audible click will notify when the
seat has changed positions.

To resume horizontal position:

Turn paddle backward, then recline
fully. An audible click will notify when
the seat has changed positions.

Engage forward tilt to support the thighs’ declined posture when performing

intensive tasks such as keyboarding.

To raise or lower arm:

Push button and pull arms up or down
to desired height.

For maximum comfort, your arms should make contact with the armpad

without any lift at your shoulders.

Arm Depth & Width:

Only available on some models.

To adjust arm depth:

Grasp arm pad, push forward or back to

desired position.

To adjust arm width:

Grasp armpad and pull in or push out.

Lumbar Height: Lever on adjustable lumbar supportArm Height: Button located on arm stalk under each arm pad

Only available on some models.

To adjust height on suspension back:

Slide lever up and down to desired
height.

To adjust height on TriFlex back:

Slide adjustable back support up and

down to desired height.

Footring Height:

Only available on Verus Stool.

To adjust footring height:

Hold base with one hand,
grasp footring spoke and turn
counterclockwise (-) to loosen.

Once loose, raise or lower footring
to desired height.

Hold collar with one hand, grasp
footring and turn clockwise (+) to
tighten. To secure, nish turning
footring while holding base.

Adjustment Guide2HermanMiller Verus™ Chair