HermanMiller Envelop Assembly Instructions Manual
Y
PARTS INCLUDED:
TOOLS REQUIRED:
1
Work Surface
2
Pin
Place the work surface on a clean flat surface.
For each tube, place a pin into the pin hole.
Make sure the flat side is pointing up as
shown in the figures above.
Ratchet
Left Support Right Support Tube (2)
Pin (2) Cap Screw (4) Button Head
Cap Screw (4)
3/16 Hex Socket
Shaft
Completed Views of Envelop
Assembly
Envelop™ Assembly Instructions
Z
© 2011 Herman Miller, Inc. Zeeland, Michig an. Printed in the U.S.A.
® Y, and Z are among the registered trad emarks of Herman MIller, Inc.
TM
Envelop is among the trademarks of Herman Miller , Inc.
Illustrations and specifications are based on the latest product informa tion available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Part no. 1b5j77 rev B.
1
3
shaft attachment positions
Attach the tubes to the work surface as illustrated in the figures on
the right.
Make sure that the holes of the
tubes are facing towards the interior of the work surface.
Secure the tubes to the work surface using the cap screws. Tighten
until firmly in place.
3a 3b
3c 3d
3/16 Hex Socket
Cap Screw
4
Front
Long Leg
Short Leg
Interior Section View
Attach the supports to the tubes as
illustrated in the figures on the right.
Make sure the long leg of each support is facing the front of the work
surface.
Secure the supports to the tubes
using the button head cap screws.
Tighten until firmly in place.
3/16 Hex Socket
Long Leg
Cap Screw
4a
4b
4c
Z
© 2011 Herman Miller, Inc. Zeeland, Michig an. Printed in the U.S.A.
® Y, and Z are among the registered trad emarks of Herman MIller, Inc.
TM
Envelop is among the trademarks of Herman Miller , Inc.
Illustrations and specifications are based on the latest product informa tion available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Part no. 1b5j77 rev B.
2
Loading...