HermanMiller Celle User Manual

HermanMiller

Celle® Chair

Seat Height: Lever under right side of seat

At the proper height, your feet should rest flat on the floor.

Seat Depth: Lever under le side of seat

Only available on some models.

In the proper position, you will have approximately three-ngers of clearance

between the back of your knees and the seat edge.

To raise:

Take your weight o chair, li lever up.

To lower:

Li lever up while seated.

To adjust:

While taking your weight o chair, li
lever and adjust seat pan forward or
back. Release lever to lock in position.

Harmonic™ Tilt Tension: Knob below front center of seat

To increase:

Turn knob clockwise.

To decrease:

Turn knob counterclockwise.

Set the tilt tension to control the resistance you feel when reclining.

Forward Tilt: Horizontal tab under le front side of seat

Only available on some models.

To position chair forward

Recline and flip tab down.

To resume horizontal position:

Recline and flip tab up.

Engage forward tilt to support the thighs’ declined posture when performing

intensive tasks such as keyboarding.

HermanMiller Celle® Chair Adjustment Guide1

Tilt Limiter: Vertical tab under le front side of seat

Only available on some models.

To engage:

Recline and move tab up to dene the
limit of recline.

Arm Height: Outside lever on top of arm support

Only available on some models.

To adjust:

Raise lever to unlock arm, adjust arm,
release lever to lock.

To release:

Lean forward and press tab back.

Engage the tilt limiter when you want to sit in an upright or partially

reclined position.

Lumbar Height: Side edges of lumbar support

Only available on some models.

To adjust:

While seated, grasp side edges of
lumbar support, slide lumbar support
up or down to desired height.

Adjust the lumbar height so that it comfortably supports the natural curve

of your spine.

For maximum comfort, your arms should make contact with the arm pad

without any lift at your shoulders.

Arm Angle & Width: Front & rear of each armpad

Only available on some models.

To adjust arm angle:

Grasp front end of armpad and pivot
it inward or outward.

To adjust arm width:

Grasp rear portion of armpad and
adjust arm in or out.

Adjust arm angle inward when using a keyboard; adjust arm angle outward

when using a mouse.

Lumbar Depth: Knob in center of lumbar support

Only available on some models.

To increase:

While seated, turn knob clockwise.

To decrease:

While seated, turn knob
counterclockwise.

Adjust the lumbar depth so that it comfortably supports the natural curve

of your spine.

In the proper position, your elbows should be in line with your shoulders.

Footring Height:

Only available on some models.

To adjust footring height:

Hold base with one hand,
grasp footring spoke and turn
counterclockwise (-) to loosen.

Once loose, raise or lower footring
to desired height.

Hold collar with one hand, grasp
footring and turn clockwise (+) to
tighten. To secure, nish turning
footring while holding base.

Adjustment Guide2HermanMiller Celle® Chair