Hercules 137303, 137307 User Manual

SAFETY DATA SHEET
1. Identification
Cloroben PT-BIO 1®Product identifier
Other means of identification
Product code
Synonyms Recommended use Recommended restrictions Manufacturer/Importer/Supplier/Distributor information
Company Name
Address
7306E Part Numbers: 137301, 137303, 137304, 137307, 137308, 137309 Liquid bioactive flow improver None known.
HCC Holdings, Inc. an Oatey Affiliate 4700 West 160th Street Cleveland, OH 44135
Telephone
E-mail
Transport Emergency
Emergency First Aid
Contact person
2. Hazard(s) identification
Physical hazards Health hazards OSHA defined hazards Label elements
Signal word
Hazard statement
Precautionary statement
Prevention Response
Storage Disposal
Hazard(s) not otherwise classified (HNOC)
216-267-7100 info@oatey.com Chemtrec 1-800-424-9300 (Outside the US 1-703-527-3887) 1-877-740-5015 MSDS Coordinator
Not classified.
Category 2Serious eye damage/eye irritation
Not classified.
Warning Causes serious eye irritation.
Wash thoroughly after handling. Wear eye/face protection. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and
easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. Store away from incompatible materials. Dispose of waste and residues in accordance with local authority requirements. None known.
3. Composition/information on ingredients
Mixtures
CAS number %Chemical name
7732-18-5 90-100Water
68439-46-3 1-5Alcohols, C9-11, ethoxylated
N/A 1-5Bacterial Cultures
Cloroben PT-BIO 1® SDS US 925937 Version #: 01 Revision date: - Issue date: 23-April-2015
1 / 6
56-81-5 1-5Glycerin
*Designates that a specific chemical identity and/or percentage of composition has been withheld as a trade secret.
4. First-aid measures
Inhalation Skin contact Eye contact
Ingestion Most important
symptoms/effects, acute and delayed
Indication of immediate medical attention and special treatment needed
General information
Move to fresh air. Call a physician if symptoms develop or persist. Wash off with soap and water. Get medical attention if irritation develops and persists. Immediately flush eyes with plenty of water for at least 15 minutes. Remove contact lenses, if
present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. Rinse mouth. Get medical attention if symptoms occur. Severe eye irritation. Symptoms may include stinging, tearing, redness, swelling, and blurred
vision.
Provide general supportive measures and treat symptomatically. Keep victim under observation. Symptoms may be delayed.
Ensure that medical personnel are aware of the material(s) involved, and take precautions to protect themselves.
5. Fire-fighting measures
Suitable extinguishing media Unsuitable extinguishing
media Specific hazards arising from
the chemical Special protective equipment
and precautions for firefighters Fire fighting
equipment/instructions Specific methods General fire hazards
Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2). Do not use water jet as an extinguisher, as this will spread the fire.
During fire, gases hazardous to health may be formed.
Self-contained breathing apparatus and full protective clothing must be worn in case of fire.
Move containers from fire area if you can do so without risk.
Use standard firefighting procedures and consider the hazards of other involved materials. No unusual fire or explosion hazards noted.
0.491Other components below reportable levels
6. Accidental release measures
Personal precautions, protective equipment and emergency procedures
Methods and materials for containment and cleaning up
Environmental precautions
Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Wear appropriate protective equipment and clothing during clean-up. Do not touch damaged containers or spilled material unless wearing appropriate protective clothing. Ensure adequate ventilation. Local authorities should be advised if significant spillages cannot be contained. For personal protection, see section 8 of the SDS.
Large Spills: Stop the flow of material, if this is without risk. Dike the spilled material, where this is possible. Cover with plastic sheet to prevent spreading. Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water.
Small Spills: Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.
Never return spills to original containers for re-use. For waste disposal, see section 13 of the SDS. Avoid discharge into drains, water courses or onto the ground.
7. Handling and storage
Precautions for safe handling
Conditions for safe storage, including any incompatibilities
Avoid contact with eyes. Avoid prolonged exposure. Provide adequate ventilation. Wear appropriate personal protective equipment. Observe good industrial hygiene practices.
Store in original tightly closed container. Store away from incompatible materials (see Section 10 of the SDS).
8. Exposure controls/personal protection
Occupational exposure limits
US. OSHA Table Z-1 Limits for Air Contaminants (29 CFR 1910.1000)
Components
Cloroben PT-BIO 1® SDS US 925937 Version #: 01 Revision date: - Issue date: 23-April-2015
Type
PEL 5 mg/m3 Respirable fraction.Glycerin (CAS 56-81-5)
Value
Form
2 / 6
Loading...
+ 4 hidden pages