Henley WEP Operating Instructions

Operating Instructions for the

Henley WEP style controller

Treatment Temperature:

Rotate temperature control
knob to desired setting.

Fluidization: Rotate blower

control knob to desired set­ting

Starting Unit—Treatment
time set:

TIME” and “FAST” or “SLOW”
button to set treatment time.

Depress “TMNT

Heater light: Light is on

when unit is heating.

To set time of day: Press

TIME SET” and “FAST” or
“SLOW” button am/pm light is
on for pm

Programmed Preheat:

(if desired) Press
“PREHEAT” and “FAST” or
SLOW” button, until the dis­play shows the time of day
for the preheat to start. Pre­heat light is on when the pre­heat is activated. Allow 30­50 minutes for heat-up.

Cautions

Temperatures higher that 140 deg F
may cause tissue damage.

Disconnect power supply before
changing fuses.

Keep air inlets clean and free of ob­structions.

Turn off unit while positioning patient.

Keep sleeves closed.

Henley