Henkel KHT-900 User Manual

www.keenovens.com

Henkel, Inc.

P.O. Box 1322

Hammond, LA

70404

[phone]

Henkel, Inc.

P.O. Box 1322 * Hammond, Louisiana * 70404 * [phone]

www.keenovens.com

Model KHT-900 Oven

Installation Instructions & Repair Parts List

One Year Limited Warranty

Henkel, Inc. warrants its products against defects in material and workmanship. Henkel,
Inc. will either repair or replace without charge any properly installed product which fails
under normal operating conditions within one year from date of installation, provided it is
returned to our factory, transportation prepaid, and our inspection determined it to be
defective under the terms of this warranty. The warranty covers only equipment
manufactured by Henkel, Inc., and does not extend to transportation, installation, or
replacement charges at the buyers’ facility; nor does it apply to any other equipment of
another manufacturer used in conjunctions with Henkel, Inc. equipment. No other
warranty, expressed or implies exists beyond that included in this statement.

Keen Ovens

Model KHT-900

Specifications

Capacity 1000lbs. / 18" rods
Volts 240 V
Watts 6000 W
Thermostat Proportional - Intergrated
Temperature 0ºF-999ºF
Insulation 4"(10.16cm) Mineral Wool
Interior Dimensions 18" X 19.3" X 36"
Net Weight 285 lbs.
Shipping Weight 305 lbs.
Shipping Dimensions 40" X 34" X 55"

Recommended Spare Parts

When it is critical to have continuous operation of this unit;

we suggest having the following spare parts on hand:

Heating Element Assembly

Contactor

General Information

The model KHT-900 is a high temperature oven designed for rebaking electrodes.
Temperatures range from 0º - 999º F. The diagonally compartmented shelf design allows
greater capacity with less oven weight. These units are constructed of steel, treated, and
then painted with a chemical resistant safety blue exterior finish and high temperature
aluminum interior finish. All models are Mercury free.

Safety Precautions

Read all instructions completely before attempting to operate this unit.

*** SAVE THESE SAFETY INSTRUCTIONS ***

To reduce the risk of electrical shock, fire, or personal injury follow the guidelines below:

• Before connecting unit to a power source, be sure the voltage supplied is the same as that specified on

the name plate of the unit.

• Check outlet to ensure proper grounding of the electrical cable. Have a licensed electrician check the

A/C power outlet if you are not sure.

• Use this unit for its intended purpose as described by literature.

• Make sure power cord is located so that it will not be stepped on, tripped over, or otherwise subjected

to stress of heat, oil, or sharp edges. Do not close doors on the cord.

• To reduce the risk of damage to the electric plug and cord, disconnect by plug rather than by the cord.

• Do not use this unit if cord or plug is in poor condition. If it has been exposed to weather or immersed

in water, have a qualified serviceman inspect and replace parts as necessary.

• WARNING! NEVER HANDLE PLUG, CORD, OR UNIT WITH WET HANDS OR WHILE

STANDING IN WATER.

• Use special care when moving heavily loaded units.