HENGDI TECHNOLOGY 1336 User Manual

PREPARING BEFORE FLYING

100

100

Fuselage

Cover

Protective

Main Frame

Cover

USB Charging Cable X1

Blade

Fly/Run Mode

Speed Setting

Left/right Turning

Automatic Mode

360°Flip

Speed Setting:
High Speed Mode - Press the button, when you hear a sound of “Beep.Beep”
Low Speed Mode - Press the button, when you hear a sound of “Beep”
Fly/Run Mode:

95

Fly Mode - Press the button, when you hear a sound of “Beep.Beep”
Run Mode - Press the button, when you hear a sound of “Beep”

50

FCC Statement:

This equipment has been tested and found to comply with the limits for Part 15 of the FCC rules. These limits

are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the

equipment

off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

AUTOMATIC MODE

• Increase the separation between the equipment and receiver.

• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

Press the automatic mode button when flying the aerocraft, it will fly in
circles automatically.

3600 FLIP

Press the 360°Flip button on the top right of the radio control transmitter
to have it perform 360°flip maneuvers!

360°Flip

CONTROL METHODS OF RUN MODE

This device complies with part 15 of the FCC rules. Operation is subject to the following

device may not cause harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

Note: Modifications to this product will void the user’s authority to operate this equipment.

two conditions: (1) This

IC Statement :

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two

conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including

interference that may cause undesired operation of the device."

IC Déclaration:

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.

L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne

l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en

compromettre le fonctionnement.

Remarque: Toute modification de ce produit annule l'autorité de l'utilisateur à utiliser cet équipement.

9

doit pas produire de brouillage, et (2)