Hello Kitty KT4557MBY User Manual

BLUETOOTH WIRELESS SPEAKER SYSTEM

USER MANUAL

KT4557MBY

PLEASE READ THIS OPERATING MANUAL COMPLETELY

BEFORE OPERATING THIS UNIT AND RETAIN THIS

BOOKLET FOR FUTURE REFERENCE.

1

IMPORTANT SAFETY INSTRUCTIONS

When used in the directed manner, this unit has been designed and manufactured to ensure
your personal safety. However, improper use can result in potential electrical shock or fire
hazards. Please read all safety and operating instructions carefully before installation and
use, and keep these instructions handy for future reference. Take special note of all warnings
listed in these instructions and on the unit.

1. The apparatus and AC adapter shall not be exposed to dripping and splashing and that
no objects filled with liquids, such as vases, shall be placed on the apparatus and AC
adapter.

2. The plug of the AC adapter is used as the disconnect device. The AC adapter should
always remain readily accessible and should not be obstructed.

3. To completely disconnect the apparatus, unplug the adapter from the power outlet.

4. Minimum distance of 4 inches (10cm) around the apparatus and AC adapter should be
made available for sufficient ventilation.

5. The ventilation should not be impeded by covering the ventilation openings with items
such as newspapers, table clothes, curtains, etc.

6. No open flame sources such as lighted candles should be placed on the apparatus.

7. The apparatus and AC adapter should be used in moderate climates.

8. Do not attempt to dismantle, open or repair this product yourself. If a fault occurs, seek
advice from your local qualified service technician or contact the distributor via the
telephone number at the back of this instruction manual.

9. The rating plate of the apparatus is located on the rear of the unit.

• Places exposed to direct sunlight or close to heat radiating appliances such as electric

heaters.

IMPORTANT NOTES

Avoid installing unit in locations described below:

• Places subject to constant vibrations.

• Dusty, humid or moist places.

COMPLIANCE WITH FCC REGULATIONS

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause

undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.

• Consult the dealer or an experienced radio/TV technician for help.

CAUTION: Changes or modifications not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment.

2

PROTECT YOUR FURNITURE !

This model is equipped with non-skid rubber 'feet' to prevent the product from moving when
you operate the controls. These 'feet' are made from non-migrating rubber material specially
formulated to avoid leaving any marks or stains on your furniture. However certain types of oil
based furniture polishes, wood preservatives, or cleaning sprays may cause the rubber 'feet'
to soften, and leave marks or a rubber residue on the furniture. To prevent any damage to
your furniture we strongly recommend that you purchase small self-adhesive felt pads,
available at hardware stores and home improvement centers everywhere, and apply these
pads to the bottom of the rubber 'feet' before you place the product on fine wooden

furniture.

ACCESSORIES INCLUDED

Carefully remove the unit and all accessories from the gift box. Please verify that you
have all the following accessories before you recycle the gift box

• BLUETOOTH SPEAKER UNIT

•AC ADAPTER

•AUX-INCABLE

• USER MANUAL

LOCATION OF CONTROLS

PLAYING MUSIC FROM A BLUETOOTH ENABLED DEVICE

1. Make sure the Power On/Off Switch is in OFF position. Insert the DC plug of the AC

adapter (Included) into the DC Input Jack at the back of the unit.

1 Power/Status Indicator

4

Power On/Off Switch

2

Full Range Speaker

5 DC Input Jack (DC9V 1.5A)

3

AUX IN Jack

6

USB Charging Port (DC5V 1A)

FRONT REAR