Heller HBOX30 User Manual

READ AND SAVE THESE INSTRUCTIONS
Instruction Manual
30cm Box Fan
Model: HBOX30
For your convenience record the complete model number (located on the product identification plate) and the date you received the product, together with your purchase receipt and attach to the warranty and service information. Retain in the event that warranty service is required.
NOTE: The rating of this product (as marked on the product identification plate) is based on specific loading tests. Normal use or the use of other recommended attachments may draw significantly less power.
IMPORTANT SAFEGUARDS
When using any electrically powered product, basic safety precautions should always be followed, including the following:
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE USING THIS PRODUCT
WARNING!: - to reduce the risk of fire, electrical shock or injury to persons or property:
Always operate the product from a power source of the same voltage, frequency and rating as
indicated on the product identification plate.
Remove the unit from its packaging and check to make sure it is in good condition before using.
Do not let children play with parts of the packaging (such as plastic bags).
Close supervision is necessary when the product is used by or near children or infirm persons. Do
not allow children to use it as a toy.
Do not operate any product with a damaged cord or plug, or after the product malfunctions, or is
dropped or appears damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
Before unplugging the power cord, be sure to turn the power off. When touching the unit, be
sure your hands are dry to prevent electrical shock.
Never install the unit where it is exposed to direct sunlight, excessive moisture/rain, dust and lack
of ventilation near any heat sources.
Avoid making contact with moving parts. Never insert fingers, pencils or any other objects
through the guards whenever the power plug is connected, especially while the unit is working.
Always place the fan on a stable, level surface when operating to prevent the fan from
overturning. Do not run the power cord under carpet. Do not cover the power cord with throw rugs or runners. Route the power cord away from walking paths so that nobody can trip over it. The cable should be kept away from heat, sharp edges and oil.
To reduce the risk of electric shock, do not immerse or expose the product or flexible cord to
rain, moisture or any liquid other than those necessary for correct operation of the product.
This product should not be used in the immediate vicinity of water, such as bathtub, washbowls,
bathroom swimming pool etc. Where the likelihood of immersion or splashing could occur.
Switch off and unplug from outlet when not in use, before assembling or disassembling parts and
before cleaning. Remove by grasping the plug - do not pull on the cord.
Be sure that no other high current appliances are plugged into the same circuit as your fan, as an
overload can occur.
Avoid the use of an extension cord as the extension cord may overheat and cause a risk of fire.
Do not use the appliance for other than its intended use.
Do not use outdoors. FOR INDOOR USE ONLY.
Do not leave the appliance unattended when switched on.
Do not cover the grill, or operate in close proximity to curtains etc.
The use of attachments or accessories not recommended or sold by the product distributor may
cause personal or property hazards or injuries.
This product is intended for normal domestic/household use only.
Never leave a working appliance unattended, even for a short period of time – always switch it
off. Please unplug the appliance from the power supply when not in use.
Use this fan as described in this manual. Any other uses, not recommended by the manufacturer,
may cause fire, electric shock, or injury to persons and may void the warranty.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
The installation of a residual current device (safety switch) is recommended to provide
additional safety protection when using electrical appliances. It is advisable that a safety switch with a rated residual operating current not exceeding 30mA be installed in the electrical circuit supplying the appliance. See your electrician for professional advice.
Children should be supervised to ensure that they do not play with the appliance.
Do not leave the fan running unattended.
WARNING: If the supply power cord is damaged, the power cord must be replaced by the
manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
This product has not been designed for any uses other than those specified in this booklet.
CAUTION: Never insert your fingers or any other objects (hair,
clothes,
utensils, knives, screw
drivers etc.) into the openings of
the
guard or close to the blade when the appliance is
connected
to the power
supply.
CAUTION: DO NOT COVER the appliance in any way in order to
avoid
overheating and
fire.
CAUTION - RISK OF ELECTRIC SHOCK: To reduce the risk of electric shock do not open this
device,
there are not serviceable parts for customers. Please
refer
any maintenance or repair to
qualified
personnel.
SAVE THESE INSTRUCTIONS
PARTS & FEATURES
1. ON/ OFF Control Switch
2. Speed Control Rotary Switch
3. Timer Rotary Switch
4. Blade
5. Louvre
6. Base
BEFORE FIRST USE
Before use, remove all packaging and inspect the appliance for any damage. If there appears to be any damage, please take the unit back to place of purchase for a replacement.
OPERATING INSTRUCTIONS
1. Mount the feet on the base of the fan.
2. Place the fan on a firm and level surface.
3. Ensure the fans rotary switch is in the ‘0-OFF’ position. Plug the unit into the power outlet and
turn the power ‘ON’. Ensure that the plug first tightly in the power outlet, as loose fit may cause
overheating, damage to the plug and socket, and create a serious safety hazard.
4. Adjust the fan speed by turning the rotary switch to the desired speed:
1 LOW
2 MEDIUM
3 HIGH
NOTE: Before inserting the plug into a power outlet, make sure that the correct voltage being used corresponds to what is indicated on the rating label, and that the socket has an earth facility.
CAUTION: To avoid of electric shock, you must always switch off and unplug the fan before cleaning.
TURN ON/OFF AND SETTING THE WIND SPEED
To turn on the fan, turn the speed control switch (1) to
positions
1, 2 or 3 according
to the desired speed you
need.
By turning the switch to the positions 1,2,3 you can
adjust
the
wind speed of the fan. To turn off the fan, just turn the switch to
position
"0".
SETTING THE TIMER
The fan stops automatically at the preset timer. If you set
the
timer to "OFF" position it will not operate
even if you switch it on so keep the timer to indication .“
ON”
CARE & CLEANING
Your appliance must be switched OFF via the main power supply and unplugged, and allow it to
cool down before proceeding with any cleaning.
Clean the housing with a damp cloth, a vacuum cleaner or a dusting brush.
We recommended lightly running a vacuum cleaner brush nozzle over the fan grille to remove
any dust or dirt that may have accumulated.
Never use flammable or abrasive cleaning agents such as benzene or spirits to clean the
appliance.
Never immerse the appliance in water.
SPECIFICATIONS
Model
Description
Voltage
Frequency
Wattage
HBOX30
30cm Box Fan
220-240V~
50Hz
40W
CUSTOMER SERVICE
Australian Customer Service GAF Control (Sales) Pty Ltd P.O Box 19 Altona North Victoria 3025 Phone: 1300 659 489 Hours: 9am-5pm (EST) Mon-Fri www.gafcontrol.com.au *This product may vary slightly to the product illustrated due to ongoing product development.
NOTE: If the power cord set of this appliance becomes damaged, discontinue use. Repairs should be undertaken only by a qualified technician.
Loading...