Heitronic 37366, 37367, 37368 Installation and operating instructions

GB Installation and Operating Instructions
LED Floodlight
Art. No. 37366,37367,37368

These operating instructions are only intended for the products listed above.
They contain important notes concerning operating the product for the first time and handling
the LED floodlight.
Therefore pay attention to these operating instructions, even if you pass this product on to third
parties.

It is important, therefore, that these instructions are archived carefully for referring to information at a
later stage.

1. Introduction

Dear customer, thank you for deciding to purchase our product.
You have acquired a product from Vollmer, which has been built according to the current state of technology.
The LED floodlight fulfils the requirements of effective European and national guidelines.
To maintain the condition of the product and to ensure safe operation, you - as the user - must observe the
instructions of this operation manual!

2. Safety Instructions

 The guarantee becomes invalid if damage occurs due to the failure of following these operating

instructions!

 We do not accept liability for any consequential damage!
 Commissioning is strictly prohibited if there are any damages to the LED floodlight.
 Do not allow children to play unsupervised near the LED floodlight or other electrical equipment.
 Do not allow the LED floodlight to come into contact with extreme heat or naked flames.
 The product in its entirety must not be altered or modified. Alterations to the LED floodlight invalidate the

guarantee.

 The type plate must not be removed.

3. Proper Use

The LED floodlight is designed for use in indoor/outdoor areas.

This product is only intended for lighting purposes and may:

 only be operated with a voltage of 230V ~50Hz
 only be connected according to protection class I (one)
 only be operated when mounted to a sturdy, level and non-tilting surface
 only be operated on normal or non-flammable surfaces
 not be subjected to strong mechanical loads or heavy soiling.

1 of 3 | Dated 18.01.2016

4. Before Installation/Commissioning

 The LED floodlight must only be used outside its packaging.
 Take the LED floodlight carefully out of the packaging.
 Make sure that the LED floodlight has not been damaged during transport before taking it into operation.

The light may not be operated if there are any damages to electrical parts. Repairs may only be carried
out by a qualified electrician.

 Keep packaging materials away from children and pets. Asphyxiation hazard!

5. Installation/Commissioning

 This product can only be installed by a qualified electrician.
 The connection lines in the building must be disconnected before installation and secured against being

switched back on. For this, trip the corresponding fuse switch in the building installation.

 Make sure that the surface is suitable for permanently and reliably taking the weight of the LED floodlight.
 Hold the light's fixing bracket at the required assembly position and mark the drill holes. Use appropriate

screws to fix the LED floodlight. Make sure that no lines are damaged.

 Do not bend the cables; make sure that the cables and plugs are not subject to tension or torsional

forces. Protect all cables and insulation against possible damages.

 Check proper connection once again.
 Switch the building installation's fuse switch back on.

6. Faulty Function

LED floodlight does not switch on

 Light switched on at the wall switch?
 Fuse switched back on after assembly?
 Check the connected lines

7. Technical Data

Article Connection LED floodlight

37366

37367

37368

230 V AC
50 ~ 60 Hz

230 V AC
50 ~ 60 Hz
230 V AC
50 ~ 60 Hz

Protec-

tion

Type

10 W, 800 lm, 120°, 3000 K IP65 I

20 W, 1600 lm, 120°, 3000 K IP65 I

30 W, 2400 lm, 120°, 3000 K IP65 I

Protec-

tion

Class

2 of 3 | 18.01.2016