Heitronic 35381 Installation and operating instructions

H. Vollmer GmbH

Heitronic

®

GB Installation and Operating Instructions
LED Solar Light Ground1
Art. No. 35381

These operating instructions refer exclusively to the product 35381.
They contain important information for the start-up and handling of the solar light.
Therefore pay attention to these operating instructions, even if you pass this product on to
third parties.

It is important, therefore, that these instructions are archived carefully for referring to information at a
later stage.

1. Introduction

Dear customer, thank you for deciding to purchase our product.
You have acquired a product from Vollmer, which has been built according to the current state of
technology.
The solar light fulfils the requirements of effective European and national guidelines.
To maintain the condition of the product and to ensure safe operation, you - as the user - must observe the
instructions of this operation manual!

2. Safety Instructions

 The guarantee becomes invalid if damage occurs due to the failure of following these operating

instructions!

 We do not accept liability for any consequential damage!
 Do not allow the solar light to come into contact with extreme heat or naked flames.
 Do not accept any liability for damages to property or personal damages caused by incorrect handling

or failure to observe the safety instructions.

 Any warranty claims become void in such cases.
 The product in its entirety must not be altered or modified. Alterations to the product invalidate the

guarantee.

 The type plate must not be removed.

3. Proper Use

The solar light is designed for use in outdoor areas.
The integrated rechargeable battery is charged by the solar cell in the upper part of the light.
The light switches on automatically at dusk and off again at dawn.
A high performance light diode (LED) is used as the source of light.
This LED guarantees high light intensity with low power consumption.

However, please note that the duration of light/light power can be negatively affected if there is little
sunlight, and also during the winter months.

Note: the battery is not charged sufficiently in case of longer periods without sunlight so that constant

availability for operation cannot be guaranteed. However, this does not mean that the solar light is
defective. Wait until the sun shines and the light will work again.

H. Vollmer GmbH
Allmendring 29
D-75203 Königsbach-Stein

Installation Instructions Art. No. 35381 Page 1 of 3 Dated 21.01.2016

H. Vollmer GmbH

Heitronic

®

4. Commissioning

1. Remove the solar light from the packaging carefully.

2. Observing the safety and warning instructions, place the solar light in the required position and press the
switch to "ON".

3. Choose a suitable place with direct sunlight to charge the light up for the first time. Make sure that the
sun is shining directly on the solar unit on the solar LED light. Shade on the solar unit impairs the battery's
charging function.

4. The solar LED light is charged using the solar panel on the top. It automatically switches on at dusk using
the day/night sensor. Make sure that the day/night sensor on the top of the light is not influenced by another
source of light, otherwise it will not switch the light on at dusk.

5. It is not possible to replace the lamp

6. The type plate must not be removed.

Note: the period of light/light intensity heavily depends on the duration and intensity of the sun's rays during

the day. A shorter period of light should generally be expected in winter. If the light does not illuminate on
the first evening, wait for one to two days of sun.

5. Faulty Function

Lamp does not switch on

 An external source of light (e.g. street light) is simulating daylight and preventing the light from

switching on. Place the light in a darker position.

Lamp does not switch on or only briefly at dark.

 Light switched on?
 Battery low or defective. Replace the battery

6. Replacing the Batteries

The batteries in solar lights must generally be replaced every 2 years on average. Please only use battery
type AAA Ni-MH 1.2 V 500mAh for this product.
The user of other batteries can lead to damages.

7. Technical Data

Article Connection Lamp

35381

1 rechargeable battery Ni-MH 1.2 V

500mAh, type AAA

LED lamp, not replaceable,

passable 5kN

Protection
Type

IP 67 III

Protection
Class

8. Care

 Leaves and dirt must be cleaned off the solar light as necessary. Please use a moist cloth to clean.
 Never use chemicals or scouring agents for cleaning. Do not apply salt in winter.

H. Vollmer GmbH
Allmendring 29
D-75203 Königsbach-Stein

Installation Instructions Art. No. 35381 Page 2 of 3 Dated 21.01.2016