Heat Wave EA1231 User Manual

EA1231

WAVEHEAT

MC

Oxford Infared Heater

User Manual

SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

If you are assembling this unit for someone else, give this manual to

him or her to read and save for future reference.

USC

INTERTEK

4001358

Call 1-877-744-3649 for assistance or email us at [e-mail]

Allen Group Int’l Inc.

377 South Lemon Ave, Suite A

Walnut, CA USA

91789

L2039

NOV 2013

1

MC

Quick Reference Guide

READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE

1. Before permanently placing your infrared heater, plug it into a
convenient outlet to verify that the circuit breakers
for the outlet are on.

2. The heater may emit a slight, harmless odor when first used.
This odor is normal and is caused by the initial heating of internal
heater parts and will not occur again.

3. If your electrical heater does not emit heat, consult your owner’s
manual for further information.

CAUTION

RISK OF ELECTRICAL SHOCK

DO NOT OPEN

NO USER-SERVICEABLE PARTS INSIDE

HIGH TEMPERATURE

KEEP DRAPERY AND OTHER FURNISHINGS AT LEAST 3.3 FEET / 1 METER
FROM THE FRONT AND SIDES OF THE ELECTRICAL HEATER.

WARNING:

1. WARNING: TO REDUCE THE RISK OF FIRE – KEEP COMBUSTIBLE MATERIAL
SUCH AS FURNITURE, PAPERS, CLOTHES, AND CURTAINS AT LEAST 3 FEET (0.9
M) FROM THE FRONT OF THE HEATER AND AWAY FROM THE SIDES AND REAR.

2. SERVICING SHOULD BE DONE ONLY WHILE THE ELECTRICAL HEATER IS
DISCONNECTED FROM THE POWER SUPPLY.

SPECIAL CHARACTERISTICS.

A) This heater is ideal for use all year round, even when central
heating has been turned off.

B) This heater produces a hot current of air.

UNPACKING AND INSTALLING THE ELECTRICAL HEATER.

1. Open the packaging carefully and remove the heater.

2. Remove and discard the plastic bag.

3. BE RESPONSIBLE HANDLING THE PACKING MATERIALS.

WARNING: KEEP PLASTIC WRAPPING AWAY FROM CHILDREN.

4. Keep the original packing for future transport and/or storage.

5. Keep the front of the unit, through which the heat is radiated,

at least 3.3 feet / 1 meter away from furniture, curtains and
other flammable objects / materials at all times.

6. Ensure there is a grounded socket nearby (back of the appliance).

7. The power cord must remain at the back of the appliance
and must not be in contact with any hot element.

IMPORTANT SAFETY INSTRUCTIONS

!

CAUTION: BEFORE OPERATING THIS
EQUIPMENT, PLEASE READ THESE
INSTRUCTIONS CAREFULLY.

!

SA 1965 SA 1965

MC

Call 1-877-744-3649 for assistance or email us at [e-mail]

WAVEHEAT

MC

WAVEHEAT

IMPORTANT SAFETY INSTRUCTIONS:

2

WARNING: Any use of this appliance other than that recommended

by the manufacturer in this owners manual may cause fire, burns,
electric shock and/or other serious injuries or death.

When using electrical appliances, basic precautions should always
be followed to reduce the risk of fire, electric shock and injury to
persons including the following:

1. Read the manufacturers instructions completely before using this
appliance.

2. This appliance will become hot when in use. To avoid burns, do not let
bare skin touch hot surfaces. The grill at the top of this heater in
particular will become hot when the heater is active. Keep combustible
materials such as furniture, pillows, bedding, paper, cloth, curtains, etc. at
least 3’ (0.9m) away from the front of the appliance. Keep all items away
from the sides and back of the appliance and take special care not to
block the air intake or exhaust vents.

3. Extreme caution is necessary when the appliance is used by or near
children or invalids and whenever the heater is left operating and
unattended.

4. Do not operate the appliance if the power cord or plug has been damaged
or the heater has been damaged or malfunctioned in any way. Take the
appliance to an authorized service facility for examination, electrical or
mechanical adjustment or repair.

5. Do not use outdoors.

6. This heater is not intended for use in bathrooms, laundry areas and
similar indoor locations. Never locate heater where it may fall into a
bathtub or other water container.

7. Do not run the power cord under carpeting. Do not cover the power cord
with throw rugs, runners, or similar floor coverings. Take care to position
the cord away from high traffic areas and such that it can not be tripped
over.

8. To disconnect the appliance, turn all controls “OFF”, then remove the plug
from the electrical outlet. Always unplug the appliance when not in use.

9. Connect to properly grounded outlets only. The appliance comes equipped
with a 3 prong grounding plug. Do not attempt to cut the grounding
prong. Connect to properly grounded 120V outlets only. This appliance,
when installed, must be electrically grounded in accordance with local
codes or, in the absence of local codes, with the current:

Canada: CSA C22.1, Canadian Electrical Code

U.S.A.: ANSI/NFPA NO. 70, National Electrical Code

10. Do not insert or allow foreign objects to enter any ventilation or exhaust
opening as this may cause an electric shock or fire, or damage the
appliance.

11. To prevent a possible fire, do not block air intakes or exhausts in any
manner. Do not use on soft surfaces, like a bed, where openings may
become blocked.

12. All electrical heaters have hot and arcing or sparking parts inside. Do
not use in areas where gasoline, paint, or flammable liquids are used or
stored or where the appliance will be exposed to flammable vapors.

13. When transporting or storing the heater, take care to keep both the unit
and power cord/plug dry, free from excessive vibration and away from
heat sources.

14. Use the heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock, or
injury to persons.

15. Always plug heaters directly into a wall outlet/receptacle. Never use with
an extension cord or relocatable power tap (outlet/power strip).

16. Do not attempt to burn wood or other materials in this heater.

17. This appliance comes equipped with an overheat protection safety
device. Should the appliance begin to overheat for any reason, the
thermal cutout of appliance will engage and then all functions of the
appliance will shut down. The appliance will have to be reset prior to
continuing use. To reset the overheat protection safety device, turn all
controls off, unplug the appliance for 15 minutes. Then plug the
appliance back in and turn on.

SAVE THESE INSTRUCTIONS

Call 1-877-744-3649 for assistance or email us at [e-mail]