Heatstore HS5810 Installation And Operating Instructions Manual
IMPORTANT SAFEGUARDS
WHEN USING ANY ELECTRICAL APPLIANCE, BASIC SAFETY
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED.
PLEASE READ ALL INSTRUCTIONS CAREFULLY
AND RETAIN FOR FUTURE REFERENCE.
IF IN ANY DOUBT ABOUT THE INSTALLATION OR USE OF THIS
PRODUCT, CONSULT A COMPETENT ELECTRICIAN.
HS5810 Tornado 2
Hi-Speed Hand Dryer
Installation and Operating Instructions
HS5810_instructions 19/4/13 08:47 Page 1
The HS5810 TORNADO 2 is a stylish, hi-speed hand dryer for
commercial applications. It has an antibacterial coating for added
hygiene, can blow hot or cool air – settable on installation. It is fitted
with a self-diagnostic function and has tamper-proof controls.
Figure 1: Components
The shaded area
indicates the
antibacterial coating
2
Important Safety Information – Please Read before Proceeding
The information contained in these installation instructions must be read
carefully before any attempt to install the hand dryer.
Failure to accurately follow these instructions may result in the incorrect
operation of the unit, damage to property and/or personal injury.
Heatstore will not be held liable for any damage to property or personal
injury as a result of failure to comply with the instructions contained
herein.
All electrical installation and repair work should be carried out by a
qualified electrician in accordance with current UK IEE regulations and
any local codes or regulations.
Any maintenance to this appliance should be carried out by a qualified
electrician.
This product must be earthed.
Isolate power to the device before installation or servicing.
Check that the electrical supply corresponds to that shown on the rating
plate on the device.
NOT to be used for any purpose other than drying hands.
The cover for the
controls is lockable
HS5810_instructions 19/4/13 08:47 Page 2
Before installation
Be sure to select a suitable position where the unit is easy to use, and
away from direct sunlight, high condensation or corrosive elements.
Choose a flat surface, away from high traffic. The unit is IPX4 rated.
Make certain that you have all the parts and appropriate tools for
installation.
Be sure that the electrical supply (via a switched fuse spur/connection
box to which you intend to connect the device) has been
isolated/switched off to reduce the risk of electric shock.
Ensure that there is no pipe work or electrical cables located directly
within the drilling area.
All pole-disconnection must be incorporated in the
fixed wiring in accordance with applicable wiring
regulations.
Installation
Note
This unit is equipped so that it can blow hot and cool air when in
operation. This may be set using the switch under the tamperproof flap on the top left-hand side of the unit, and should be set
during the installation of the appliance – see figure 2/2a.
Electrical
Use a single-phase alternating current 220V-240V
power supply.
This unit comes pre-wired ready for installation.
Installation
The left side of the unit must be at least 150mm away
from any walls to allow access to the control panel.
Before ‘offering up’ the backplate and marking the wall:
remove the drain tank as you would for
cleaning – see page 6.
remove the cover by removing the 2 screws
behind the drain tank – see figure 3.
remove the one screw located behind the drain
tank to remove the back plate.
remove the separate backplate from the main
unit ready for fixing to the wall.
Figure 3: retaining screws
Figure 2a
Figure 2
3
HS5810_instructions 19/4/13 08:47 Page 3
Loading...