Heat Seal MWS-M-18 User Manual

Magic Wand Systems and Options

Models: MWS

Model MWS-I-18 shown with optional heat gun

Model MWS-M-18 shown

MODEL MWS-I: TIMED IMPULSE HEAT

The sealing wire is activated by a push button switch which
heats the wire to cut and seal the film being used. The heating
cycle is determined by adjusting the seal timer on the power
pack. Following one complete cycle, the sealing wire will cool
until triggered again. This unit provides for greater sealing
consistency as the timer controls the exact heat to the sealing
wire during every heating cycle.
Available in sizes: 18”, 24”, 36”

Specification Sheet

Model MWS-I-18 shown

MODEL MWS-M: MANUAL IMPULSE HEAT

The same system as the MWS-I except the operator controls
the length of the heating cycle by depressing and holding the
button switch. The unit is not automatically cycled off, but be­gins the cool down cycle as soon as the button is re­leased. Available in sizes: 18”, 24”

Revised 2014

FEATURES

Fully Portable

For Use with All Flexible Films, up to 10 mil
thick

Sealing Wand with Power Pack

Neoprene and Silicone Sealing Pads

Film Dispenser with Separator Bar

Hole Punch

Service Parts

AVAILABLE OPTIONS

24” Sealing Block

Aluminum Table Options (MWST): 28” D, 44” W, 29”H
OR 43” D, 44” W, 29” H

MODEL SPECS

MODEL MWS-M-18 MWS-M-24 MWS-I-18 MWS-I-24 MWS-I-36

TYPE

SEALER LENGTH

POWER

REQUIREMENT

WATTAGE

WORKING

HEIGHT

WEIGHT

Adjustable Height Legs for Table 29” to 38” Overall Height

Hot Air Gun 300-500 Degree F HG-115V (5402083)

Hot Air Gun Dual Heat 125V/1500W HD966 (5402081)

Manual Impulse Timed Impulse

18” 24” 18” 24” 36”

115 Volt, 10 Amp, 60 Cycles,

Single Phase Circuit with Ground

1,150 Watts

Table Top

9 lbs.(4 kg) 14 lbs.(7 kg)