Heat Seal MWS-C User Manual

R

Model MWS-C-24” Long Seal Bar Table Top System

PACKAGING SYSTEMS

MAGIC WANDS

PORTABLE SHRINK

PACKAGING SYSTEM

Features of the Magic Wand

Standard 115 Volt Power Supply

Fully Portable

Sealing Wand With Power Pack

Neoprene And Silicone Sealing Pads

Film Dispenser With Separator Bar

Hole Punch

Model MWSBT-C-24 With Optional Adjustable
Legs, Casters and Label Dispenser

Crafted with pride in the

U

L

®

Listed

C

MEMBER

PMMI

R

Service Kit

Specifications and Options

Power Requirement:

Wattage:
Working Height:
Weight:

Constant Heat: (3.17 kg)
Impulse Heat: (6.35 kg)

Manual Impulse Heat:

Warranty:

Options:

220 Volt Power Supply
HG-966 Hot Air Gun
HG-115V Hot Air Gun
HG-302A 220 Volt Heavy
Duty Master Hot Air Gun

115 Volt, 10 Amps, 60 Cycles
Single Phase Circuit With Ground
1,150 Watts
Table Top
(Wand and Power Pack Only)

7 lbs.
14 lbs.

9 lbs.

(4.08 kg)

Ninety Days On Parts

24” Sealing Block
MW Alum. Tables In 2 Sizes

28” D, 44” W, 29” H

43” D , 29” H
Adj. Height Legs For Table
29” To 38” Overall Height

, 44” W

YOUR BEST CHOICE FOR ALL YOUR WRAPPING NEEDS

Available Magic Wand Systems

Model MWS-C: Constant Heat

The sealing wire remains heated as long as the
unit remains on. The wire is protected by an
aluminum guard to protect the operator. The user
must press down on the spring loaded sealing
arm in order to cut and seal the film being used.

Available sizes: 18”, 24”, 36”

Model MWS-I: Timed Impulse Heat

The sealing wire is activated by a push button
switch which heats the wire to cut and seal the
film being used. The heating cycle is determined
by adjusting the seal timer on the power pack.
Following one complete cycle, the sealing wire will
cool until triggered again.

This unit provides for greater sealing consistency
as the timer controls the exact heat to the sealing
wire during every heating cycle.

Available sizes: 18”, 24”, 36”

Model MWS-M: Manual Impulse Heat

The same system as the except the
operator controls the length of the heating cycle
by depressing and holding the button switch. The
unit is not automatically cycled off but begins the
cool down cycle as soon as the button is released.

Available sizes:

18”, 24”

MWS-I

For Additional Product Information, Contact:

HEAT SEALING EQUIPMENT LLC

4580 EAST 71ST STREET CLEVELAND, OHIO 44125

[phone] [phone] FAX [phone]

R

WEBSITE www.heatsealco.com E-MAIL [e-mail]