Heat Seal MWS-C Installation Manual
R
OPERATING INSTRUCTIONS
Model MWS-C Constant Heat Wrapper
IMPULSE AND CONSTANT HEAT WRAPPERS
MAGIC WAND SERIES
Model MWS-I Timed Impulse Heat Wrapper
Model MWS-M Manual Impulse Heat Wrapper
PLEASE READ THESE INSTRUCTIONS
THOROUGHLY BEFORE USING
© 2005, 11-7 Magic Wand Wrapping Instructions
OPERATING INSTRUCTIONS
1
2
3
4
5
HOW TO USE THE MAGIC WAND SYSTEM
SETTING UP THE STATION
On the film dispenser, adjust separator plate (1)
with the two thumbnail screws and two hex nuts
and washers provided.
Slide separator bar (2) into separator plate, adjust
to desired angle, then tighten thumbscrew (3).
Place the film dispenser on the right hand side of
your table. Place shrink film roll (4) on the
dispenser with the film winding from the bottom of
the roll (5).
Page 2
OPERATING INSTRUCTIONS
7
6
8
9
11
10
HOW TO USE THE MAGIC WAND SYSTEM
SETTING UP THE STATION
After threading the film through the separator bar
(6), place black sealing pad (7) down on the table
just to the left of your film dispenser.
Place the red pad (8) over the black sealing pad
and you are ready to get started. After plugging in
the power pack, turn switch (9) to the
position. (Remember to turn to when
leaving the wand unattended.)
Now pull the shrink film (10) onto the top of the
sealing pads (11).
“OFF”
“ON”
Page 3
Loading...