Heat Seal 102A Parts List
OPERATING & SERVICE PARTS MANUAL
FLOOR MODEL OVERWRAPPERS
AXLE MOUNT MODELS:
TWO ROLL CAPACITY WITH MOUNTING AXLES
SPLASH SHIELD AND 6” X 15” HOT PLATE
THREE ROLL CAPACITY WITH MOUNTING AXLES
MODEL 102A
MODEL 104A
AND 8” X 15” HOT PLATE
Model 107A
Model 112A
MODEL 107A
THREE ROLL CAPACITY WITH MOUNTING AXLES
SPLASH SHIELD AND 8” X 15” HOT PLATE
MODEL 112A
COMPACT THREE ROLL CAPACITY
MOUNTING AXLES AND PACKAGE REST
MODEL 112AHP
COMPACT THREE ROLL CAPACITY
MOUNTING AXLES AND 6” X 15” HOT PLATE
READ ALL INSTRUCTIONS CAREFULLY BEFORE OPERATING EQUIPMENT
Revised 2014
TABLE OF CONTENTS
Film Threading & Mounting .......................................................................................... 3
102-104-107A Schematic & Parts List .......................................................................... 5
112A & 112AHP Schematic & Parts List ....................................................................... 6
Electrical Service Information ...................................................................................... 7
Electrical Schematics .................................................................................................... 8
Electrical Box & Hot Plate Schematic & Parts List ..................................................... 9
2
Revised 2014
FILM THREADING & MOUNTING
THREADING THE FILM:
Thread the film as shown, one at a time or as needed.
MODEL 102A MODEL 107A
MODEL 104A MODEL 112A
FILM SELECTOR
Pull different sized films into film selector and drape unused film
in front of roller.
TO CHANGE FILM WIDTHS:
1. Lift up both handles
2. Move evenly forward or backward
3. Lower into slots
MOUNTING FILM ON AXLE
1. Loosen four wing nuts (A)
2. Swing out upper bearing blocks (B) on both sides
3. Lift out axle assembly (C) and unscrew movable
end cap (D), position fixed end cap (E) for correct
film width then secure with pin (F) and o-ring (G)
4. Position the cardboard core of the film roll against
the taper of the fixed end cap. Make sure the film is
threaded from the bottom of the roll and under film
roller (H) (see threading diagrams)
5. Replace adjustable end cap (D) and screw on tightly
6. Replace the axle assembly (C) and film roll onto
the lower bearing blocks (J), swing upper bearing
blocks (B) back into place and tighten and adjust
wing nuts (A) for desired film tension
ITEM PART # DESCRIPTION
Bearing Block Set, Includes:
1 6305-018
2 6110-023
3005-004
3
3005-047
Upper Bearing Block, RH
Upper Bearing Block, LH
Lower Bearing Blocks
3” Core Adapter Set Includes:
3” Adjustable Core
3” Fixed Core
Core Axle, 21 15/16” L
Core Axle, 24” L
3
Revised 2014
Loading...