Heatsail DOME User Manual
U S E R M A N U A L
For the most recent version of this manual check our website.
www.sutherlandfurniture.com
Do not discard this manual, it contains your device’s serial number.
INTRODUCTION
ELECTRICAL SAFETY PROCEDURES
1
2
3
4
5
6
7
OPERATIONAL SAFETY
MAINTENANCE
WARRANTY CONDITIONS
APPLICABLE LAW
ASSEMBLY AND WIRING INSTRUCTIONS
OPERATION
6
6
8
10
11
12
25
8
TROUBLESHOOTING
CONTACT INFORMATION
26
30
Thank you for your purchase!
This user manual is inextricably connected to the DOME® and
must always be kept by the user or by another authorized
responsible person.
Please read through this user manual carefully. It contains
essential information regarding the safety, operation, cleaning
and maintenance of the DOME. Heatsail will not be held
responsible for injury and/or damage to people, animals and
subjects resulting from non-compliance with the instructions
in this user manual.
Heatsail reserves the right to make changes to the product,
the technical features and the user manual at any time and
without the need for prior notice.
If you decide to sell the DOME, transfer it to another user
or leave it behind when moving, this manual must be made
available to the new user.
We would like to wish you plenty of warm and pleasant
evenings with our DOME!
The HEATSAIL team.
4 Heatsail DOME®
User manual
Operating, maintenance and installation guide.
Attention
Please read through these instructions carefully before using your DOME.
Do not discard this manual, as it contains your device’s serial number.
5User manual
1. Electrical safety procedures &
requirements
The use of the DOME requires an electrical installation with reliable safety
grounding. The installation’s electrical safety can only be guaranteed if
the device has been correctly connected to a grounding (earthing) system
built in accordance with the safety instructions. A preliminary inspection is
absolutely essential. In the event of any uncertainty, a careful inspection
must be made by a qualified and authorized technician. Heatsail will not be
held responsible for injury and/or damage resulting from an ungrounded
installation.
The installation of the DOME’s electrical components requires a mains
connection of 240V-50/60Hz (16 Amp fuse EN 30 mA RCD): the connection
must be properly implemented in accordance with the applicable IEC-CEI
standards. Please note: statutory and other local regulations may apply.
This product must by installed by a licensed electrician and the power
supply connection should be in accordance with the requirements of
NFPA 70 and OSHA Regulations 29 CFR 1910.304(b)(2)
Before carrying out any maintenance or other work, the power supply
must be disconnected by a licensed electrician. Use Lock-out/Tagout procedures to ensure that the power can’t be switched on again
accidentally.
The use of adapters, power strips and extension cords may not be used
for the DOME’s electrical supply. A switch must be installed between the
DOME and the fuse box at all times. Non-compliance with these instructions may compromise the safety of the device. Heatsail will not be held
liable for any damage resulting from these issues.
2. Operational Safety
A minimum clear height of 71 inches (1.80 meter) must be observed for the
DOME, measured between the ground and bottom of the lowest heating
element at the time of installation.
6 Heatsail DOME®
Children must be under adult supervision at all times when near this product, when in use. This product is not intended to be operated by children,
to be played with or to be played on. The DOME must be kept out of reach
of anyone incapable of assessing the risks which can arise from the (improper) use of electrical equipment.
Do not use the DOME in small rooms when occupied by persons not capable of leaving the room on their own, unless constant supervision
is provided.
CAUTION – The DOME can create extremely high temperatures
and can cause burns. The DOME should never be touched once it
has been switched on.
Particular attention should be paid when children and vulnerable persons are present.
The DOME will remain hot for a considerable period of time after it has
been switched o. Do not touch the DOME for a period of 40 minutes after
it has been switched o.
Caution should be exercised at all times. The grill does not oer
protection against the heat.
The DOME must never be used when the glass is damaged.
The DOME may not be used with a timer or any device which can
automatically switch on the heating, as there is a risk of fire if the DOME
has been incorrectly positioned or if items have been placed within
the minimum safe operating distance.
Never use the DOME in the immediate vicinity of a bath, jacuzzi, shower,
or swimming pool.
To reduce the risk of fire, keep textiles, curtains, or any other flammable
material a minimum distance of 40 inches (1 meter) from the DOME.
Never cover your DOME without disconnecting power to the unit!
7User manual
The DOME must never be touched with bare, wet or damp body parts.
The DOME is constructed of six high radiance ceramic heating elements,
mounted on a reflective plate. The full operating temperature will be
reached within 30 minutes. Please note: there is no noticeable glow in the
infrared area.
Never use the DOME to light anything. The ceramic elements are fragile
and must be handled with care. The same also applies to the glass casing.
Always ensure that the DOME is anchored on a flat surface before use.
Always keep the DOME free of snow. The dome is not allowed for use
in greenhouses or building sites.
Heatsail will not be held responsible for damage resulting from
non-compliance with the instructions regarding use and maintenance.
3. Maintenance
3.1 Cleaning
Your DOME must be cleaned on a monthly basis.
The electrical supply must be disconnected via the installation’s breaker
switch and by disconnecting the wiring before cleaning activities can commence. Cleaning may only be done with a dry and soft cloth. Do not use
any abrasive cloths. Do not use detergents. Using a high pressure and/or
steam cleaner is prohibited. Cleaning is only permitted once the DOME
has completely cooled down.
Non-compliance with these rules may compromise the safety of the device. Heatsail will not be held responsible for damage resulting from
non-compliance with the cleaning instructions.
8 Heatsail DOME®
3.2. Replacing the bulb
Your DOME is supplied with a R7S 230V/120 Watt (78mm) halogen bulb
as standard. The maximum permitted output power of the bulb is 120 Watt.
The electrical supply must be disconnected via the installation’s breaker
switch before the bulb can be replaced.
You can replace the bulb by carefully sliding the glass upwards. Use a
tool (like a screwdriver) to hold up the glass. The bulb is held in place by a
spring. Remove the bulb by first pushing it to the left or right and thereby
releasing it from its socket. Then replace the bulb and reverse previous
steps. Please be careful never to touch the halogen bulb with bare fingers,
as oils from skin will significantly reduce bulb life.
3.3. Inspection
The DOME must be subjected to an annual inspection.
The user is not authorized to carry out his own inspections and repairs.
Inspection of the DOME must exclusively be carried out by qualified and
authorized technicians, in accordance with Heatsail’s applicable standards
and regulations. “Qualified technicians” are understood to mean: people
who have completed a technical training course for the installation of
outdoor heating and who are familiar with the applicable electrical laws
and regulations.
The electrical supply must be disconnected via the installation’s mains
breaker or by disconnecting the plug before any work can be carried out.
All repairs must be requested via an authorized distributor of Heatsail
products.
A repair is only valid when original parts have been used.
Upon written approval by Heatsail, the entire control panel should be returned in case of a defective cable.
Heatsail will not be held responsible for damage resulting from noncompliance with the maintenance instructions.
9User manual
Loading...