Heath Zenith 3035748, AC-6195 User Manual

Ba tter y

Wireless Chime

Accessory Receiver

This package includes:

• Wireless chime

• Hardware pack You'll need to buy 3 "D" alkaline batteries for the chime. In typical use,

alkaline batteries will last three years.

Model 3035748 (AC-6195)

Chime

Volume

2. Install the 3 al-

kaline "D" batterie s. Ma ke

sure batteries ar e or iente d properly.

1. Open chime case:

Press in catch on bottom of chime and lift the case open.

3. Test Range. Temporarily position chime where you want it mounted. Press

push button to verify chime and push button work properly. If chime does not sound, see Troubleshooting.

4. Mount accessory chime.

Chime can be mounted by using 3 holes in the back of case, or by using 2 screws with keyholes.

Holes

for Wall

Mounting

Chime Back

Case Mounting

Snap front of chime case on. Start with top edge of case aligned with the top of back plate.

3-5/16"

(8.4 cm)

Chime Back Case

Keyhole Mounting

Close Chime Case

Code and Tune Settings

Code Settings

Note: Most installations will not require you to change any of the jumpers on your chime and push button.

The push button and chime communicate by using a code that can be changed by removing and/or adding jumpers on both the push button and chime. The code is factory set; however, there are 128 selectable codes that allow you to expand your system and prevent outside interference. Other wireless products may cause interference and the system may not function properly. Follow the instructions below for setting a new code.

1. Open the cases and locate jumpers on both the push button and chime (See illustration on page 3).

2. The push button and chime both have eight different jumper locations. The jumper positions 1 through 7 are used for setting the code.

3. To change the code, add and/or remove jumpers as needed. It is recom mended to only change one jumper at a time and then check to see if system is functioning properly. Note: Jumpers in positions 1 through 7 must be exactly the same for both the push button and chime for this system to function.

Tune Settings

Your wireless chime has different selectable tunes: Ding (one note), Ding-Dong (two note), or Westminster (eight note) (Available on selected chimes). The factory setting is for the Ding-Dong tune (or Westminster, when available). This tune can be changed by following the instructions below.

• Ding (one note tune)

Push Button: Add a jumper to location 8.

• Ding-Dong (two note tune)

Push Button: Remove jumper from location 8. Chime: Remove jumper from location 8.

• Westminster (Eight note tune) (Available on selected chimes)

Push Button: Remove jumper from location 8. Chime: Add a jumper to location 8.

Note: All models have both front and back door tune capabilities. You may purchase any ACE® wireless push button for a second entrance. We recommend the back door use the Ding tune and the front door use the Ding-Dong tune (or Westminster tune, available on selected chimes). Models that include two push buttons will come factory set for front and back doors. Decals on the rear of the push button will indicate its setting.

-2-

598-1075-03

Battery

Push Button Battery Replacement

Install an alkaline type A23 12 Volt battery. The

positive terminal should be positioned as shown.

1 2 3 4 5 6 7 8

Tune Setting (Not used on

all models)

Inside Chime

1 2 3 4 5 6 7 8

Inside Push

Button

Note: Some models might require the use of

tweezers to remove and replace the jumpers.

* Code Settings 1-7

Must Match Both Push Button and

Chime

Tune

Setting

Troubleshooting

Chime does not sound:

• Make sure push button and chime codes are the same (See pages 2 and 3).

• Check orientation of push button battery (See page 3).

• Check charge of push button and chime batteries, replace if necessary.

Batteries seem OK, but the chime does not work when installed:

• Do not mount chime or push button on metal or near metal studs. This reduces the transmitter range. Use 1/4" to 1/2" (6 to 13 mm) wood shims to move chime or push button off metal surface.

• Concrete ﬂoors may reduce range. Move chime away from ﬂoor.

• Try locating chime closer to push button.

The range of the wireless chime can vary with location, temperature and battery condition.

ACE® reserves the right to discontinue and to change speciﬁcations at any time without notice without incurring any obligation to incorporate new features in previously sold products.

598-1075-03

-3-

Please call 1-800-858-8501 (English speaking only) for assistance

If you experience a problem, follow this guide. You may also want to visit our Web site at: www.hzsupport.com. If the problem persists, call* for assistance at 1-800-858-8501, 7:30 AM to 4:30 PM CST (M-F). You may also write* to: HeathCo LLC P.O. Box 90004, Bowling Green, KY 42102-9004 ATTN: Technical Service * If contacting Technical Service, please have the following information available: Model Number, Date of Purchase, and Place of Purchase.

before returning product to store.

No Service Parts Available for this Product

Technical Service

This device complies with Part 15 of the FCC Rules and RSS-210 of Industry Canada.

Regulatory Information

Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

The user is cautioned that changes or modiﬁcations not expressly approved by the party responsible for regulatory compliance could void the user’s authority to operate the equipment.

This is a “Limited Warranty” which gives you speciﬁc legal rights. You may also have other rights which vary from state to state or province to province. For a period of ﬁve years from the date of purchase, any malfunction caused by factory defective parts or workmanship will be corrected at no charge to you. To obtain a refund or a replacement, return the product to the place of purchase. Not Covered - Repair service, adjustment and calibration due to misuse, abuse or negligence, and expendable items are not covered by this warranty. Unauthorized service or modiﬁcation of the product or of any furnished component will void this warranty in its entirety. This warranty does not include reimbursement for inconvenience, installation, setup time, loss of use, or unauthorized service. This warranty covers only ACE® assembled products and is not extended to other equipment and components that a customer uses in conjunction with our products. THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTY, REPRESENTATION OR CONDITION OF MERCHANT ABILITY OR THAT THE PRODUCTS ARE FIT FOR ANY PARTICULAR PURPOSE OR USE, AND SPECIFICALLY IN LIEU OF ALL SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES. REPAIR OR REPLACEMENT SHALL BE THE SOLE REMEDY OF THE CUSTOMER AND THERE SHALL BE NO LIABILITY ON THE PART OF ACE® FOR ANY SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO ANY LOSS OF BUSINESS OR PROFITS, WHETHER OR NOT FORESEEABLE. Some states or provinces do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. Please keep your dated sales receipt, it is required for all warranty requests.

FIVE YEAR LIMITED WARRANTY

-4-

598-1075-03

+ 8 hidden pages