HeathCo WRC6033TX User Manual
DRAFT COPY
ENGLISH
Remote Controlled Products
This manual includes operating instructions for a variety of remote controlled products. All products work on the same principle and use the same
code setting information. Please read all instructional information and note any specific information pertaining to your particular product.
FEATURES
• Products are UL/cUL and/or FCC/IC tested and approved.
• Operational range of up to 100 feet.
Heath
®
/Zenith wireless lighting controls are designed to work together. Simply determine which transmitter(s) you would like
to have control which receiver(s) and set the code setting to match.
CODE SETTINGS
Note: Most single system installations will not require any
change to the code setting. Transmitter(s) and receiver(s)
must have the same code and group setting to work together.
Switches 1 through 3 set the code. Switch 4 sets the Group
(A or B). See page 2 for switch locations.
Transmitter(s)/
Receiver(s) Code
Group “B”
Example 1 - Code Settings, System 1
(Factory Setting)
Transmitter(s)/
Receiver(s) Code
Group “A”
( – Indicates Position of Switch)
Example 2 - Code Settings, System 2
Note: When operating more than one system independently of each
other, set each system to a different code. There are 8 codes available by changing the settings of switches 1 through 3.
Transmitter(s)/
Receiver(s) Code
Group “A”
© 2006 DESA Specialty Products™ 598-11271-00
CODE SWITCH LOCATIONS
Solar Powered Motion Sensor
Code
Switches
ON
DUALBRITE® ON-TIME
Off 3Hr Dusk to TEST 1 5
Dawn (Mins)
CODE RANGE DETECT
1 2 3 4 MIN MAX NIGHT DAY
ONLY NIGHT
ON
1 2 3
4
Close-Up of Typical Code Switch
(Factory Default Setting is Off)
Note: The “X” has been placed on the switches to help clarify the
code settings on the previous page.
2 598-1271-00
DRAFT COPY
SOLAR POWERED MOTION SENSOR
Features:
• No wiring required.
• Up to 80 feet sensing range, 360° Coverage.
• Adjustable sensitivity.
• Day/Night or Night only operation.
• Optional half power accent lighting
• Test mode.
• Uses 2 AAA NiMH rechargeble batteries
(included).
• Controls receivers up to 100 feet away.
Solar Powered
Motion Sensor
L
o
c
k
U
n
l
o
c
k
Installing Batteries
1. Remove battery compartment cover by rotating clear solar
panel cover counterclockwise.
2. Install 2 AAA NiMH rechargeble batteries (included) according
to polarity markings inside the battery compartment.
3. Replace battery compartment cover by reversing the above
instructions.
L
o
c
k
U
n
l
o
c
k
L
o
c
k
U
n
l
o
c
k
Removing Solar Panel Cover / Battery Compartment - Top
View
Clear Solar Panel Cover
Rotation Indicators
Solar Panel Cover / Battery Compartment - Bottom View
Loading...